Parts for Maytag MDE18CSAGW0: 01 - Top And Console Parts

Pilot light not visible or broken lens? This control panel lens cover protects the indicator bulb and diffuses light. Simple snap-in replacement part.

Dryer won't advance through cycles or stops mid-cycle? The cycle switch controls the timer progression. Moderate DIY repair, 30-45 minutes.

Dryer won't start when you press the button? This push to start switch initiates the drying cycle. Simple repair restores one-touch operation.

This is a 230-volt indicator lamp used in a clothes dryer to signal when a cycle is running or a specific setting is selected. It mounts on the control panel and illuminates to provide visual feedback during operation. Replace this lamp if the indicator light on your dryer control panel no longer lights up even though the dryer is functioning normally.

This is the front-facing control panel (console assembly) for a dryer, in white. It houses the buttons, knobs, and display used to select cycles, temperatures, and other dryer settings. Replace this panel if the buttons are unresponsive, the panel is cracked, or if cycle selections no longer register properly.

Replace worn, stripped, or missing 8-18 x 3/8 machine screws that secure control panels, trim pieces, and brackets on your appliance. Restores tight fit.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

Washer won't start or door won't unlock? This lock cam drives the door lock mechanism to secure and release the door for proper cycle operation.

Case cushion for dryers. Installs on the exterior cabinet to provide vibration dampening. Replace if your cushion is cracked, worn, or missing.

Replace your dryer's top panel if it's cracked, dented, or damaged. This panel covers the top of your dryer cabinet and provides access to components.

If your dryer won't start or heat, the relay may have failed. This switch controls electrical current to the motor and heating element.

This foam seal cushions and seals the icemaker area to reduce vibration and prevent air leaks that can affect ice quality and efficiency. It's a direct-fit replacement designed to restore proper sealing around the icemaker housing. What it does:

• Cushions the icemaker assembly to reduce noise and movement
• Helps seal gaps to limit warm air intrusion that can cause icemaking issues
• Supports consistent ice production by maintaining the intended airflow path
• Resists compression set for reliable sealing over time

• One foam seal for the icemaker housing

• Basic installation; remove power to the appliance before starting
• Align the seal to the icemaker housing, pressing into place until fully seated
• Inspect surrounding surfaces for debris or damage and clean before installing