Parts for Maytag MGDB950YW2: 01 - Top And Console Parts

Dryer won't start or stops mid-cycle? This electronic control board regulates all dryer functions. Moderate DIY repair with console disassembly required.

This is the control knob assembly for the appliance's control shaft. It lets you select settings by turning the shaft without tools. A worn or cracked knob can slip, spin freely, or make it hard to set temperatures or cycles.

• Rotates the control shaft to adjust settings
• Replaces knobs that are cracked, stripped, or hard to turn
• Helps restore precise selection of temperatures and cycles
• Common symptoms include a loose knob, no response when turning, or difficulty gripping

• Disconnect power and allow hot surfaces to cool before service
• Pull the old knob straight off the shaft; avoid prying against the panel
• Align the new knob with the shaft flat and press firmly until seated
• Test operation through the full range of settings

Fix a dryer that won't start, times incorrectly, or fails to run cycles with this electronic control board. Restores normal console operation.

Screw for control panel.

Self-drilling screw secures panels, brackets, and trim without pre-drilling. Replace missing or stripped screws during appliance repair or reassembly.

Secures dryer drum components and prevents rattling. Replace if broken or missing to restore quiet operation. Verify fit with your model number.

Replacement mounting screw for dryer assembly. Used to secure internal components and panels. Order a new screw if original is stripped, lost, or damaged.

Replace your dryer seal to prevent air leaks and maintain drying efficiency. Install when you notice gaps or worn sealing. Verify fit with your model number.