Parts for Whirlpool WGD9150WW1: 01 - Top And Console Parts

White dryer top panel that covers the drum and internal components. Replace if cracked, damaged, rusty, or worn from heavy use or chemical spills.

Replaces a worn, broken, or missing control knob spring for your dryer. This small spring installs behind the control knob to provide tension.

Structural bracket that secures components inside your dryer. Replace if bracket is rusty, bent, broken, or missing to restore proper support and alignment.

This is a single replacement screw used to secure appliance panels and components. It restores proper fastening to help eliminate looseness and rattling and keep parts aligned for safe operation. What it does:

• Secures trim, panels or internal components to maintain proper alignment
• Prevents rattling or vibration caused by loose fasteners
• Replaces missing or stripped screws for safe, reliable fit
• Works wherever the OEM screw specification and fit match the original

• One screw as shown

• Disconnect power and/or gas before accessing internal components
• Use the proper driver size and avoid over-tightening to prevent thread damage
• Verify correct screw placement against the appliance's service diagram

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This replacement control knob assembly restores a solid, accurate feel when selecting settings on your appliance. Replace cracked or stripped knobs to regain smooth control and a clean, like-new appearance.

• Interfaces with the control shaft so you can select functions and settings
• Common failure signs: cracked or broken knob, stripped insert, wobbly fit, falls off, hard to turn, or missing knob
• Restores proper grip and pointer alignment for accurate adjustments
• Direct replacement engineered to match the original fit and function

• Disconnect power and allow any hot surfaces to cool before servicing
• Pull the old knob straight off the control shaft; avoid prying on the control panel
• Align the shaft/keyed flat with the new knob and press firmly until fully seated
• Verify smooth operation through the full range of settings