Parts for DG27CW1-96116A: Top Deck / Electronics Parts

This is a stainless steel #8 x 5/8" Phillips screw sold in a pack of 10 — a direct-fit fastener for appliance panels, brackets, and trim. Durable corrosion resistance helps maintain secure assemblies over time. What it does:

• Fastens panels, brackets, trim pieces, and other appliance components using a Phillips driver
• Stainless finish resists rust and corrosion in humid or wet appliance areas
• Sized for common appliance mounting points where #8 x 5/8" screws are specified
• Helps restore loose or missing fasteners that cause rattling or poorly seated panels

• Ten (10) stainless steel #8 x 5/8" Phillips screws

• Use the correct #2 Phillips bit and moderate torque to avoid stripping the head or damaging mating parts
• Tighten until snug; do not overtighten plastic components
• Disconnect power to the appliance before accessing internal panels or wiring
• Keep loose screws away from children and dispose of packaging responsibly

This DX LCD display module replaces a failed control display to restore clear readouts and touch feedback on the appliance. It's the user-interface board that shows settings, status, and error codes so you can operate the unit normally again. What it does:

• Replaces a broken, dim, or unresponsive LCD display on the appliance control panel
• Restores visible cycle information, timers, and on-screen status messages
• Helps resolve symptoms like blank screen, scrambled characters, or inconsistent touch response
• Interfaces with the main control to display error codes used for diagnostics

• Disconnect power to the appliance before attempting service to avoid shock or damage.
• Handle the module carefully; avoid contact with circuitry and protect against static discharge.
• Reassemble panels and seals per the appliance's service instructions to maintain proper fit and safety.

The Lid Assembly is an OEM part for Fisher & Paykel dryers. It consists of the dryer lid and attached hinges, which provide controlled access to the drying chamber.

Symptoms of a bad lid assembly include:

• Difficulty opening or closing the dryer lid
• Loose, unstable, or off-track movement of the lid
• Gaps in the lid seal letting heated air escape

Causes of failure can be stripped or worn-out hinges, broken seals or cracked plastic over prolonged use. Overloading the dryer can also put excess stress on the lid assembly.