Parts for Electrolux EI30DS55LBB: 09 - Top / Drawer Parts

This is a metal or finished side panel that attaches to the warming drawer section of the range. It provides structural support and a clean exterior appearance on the side of the drawer compartment. Replace this panel if it is dented, scratched, rusted, or missing, which can affect both the look and proper operation of the warming drawer.

If your gas burners won't light or igniters aren't sparking, the spark module likely needs replacement. DIY-friendly repair, typically 10-15 minutes.

This is the outer frame for a warming drawer, finished in black. It surrounds the drawer front and provides structural support as well as a finished appearance. Replace this frame if it is bent, cracked, or if the drawer no longer sits flush with the range body.

This black burner cap sits on top of the 14,000 BTU surface burner on a gas range or cooktop, distributing the flame evenly around the burner head. It is essential for proper flame pattern and efficient heating. Replace this cap if it is cracked, warped, heavily corroded, or if the burner flame appears uneven or yellow.

Burner cap covers the burner head on gas ranges and cooktops. Replace if cracked, chipped, broken, or missing to protect burner and ensure proper heat.

Replacement burner cap for gas range cooktops. Sits atop the burner head to distribute flame evenly. Replace if cracked, damaged, or missing after moves.

Replacement burner cap for gas ranges and cooktops. Covers the burner head and protects from spills. Needed when cap is cracked, broken, or missing.

Removable griddle plate that sits over range burners to create a flat cooking surface. Replace yours if cracked, warped, or worn for even cooking.

This is the electric heating element located inside the warming drawer of a range. It provides low, steady heat to keep cooked food warm until serving. Replace this element if the warming drawer no longer heats, heats unevenly, or if the element is visibly damaged or burned out.

Oven not heating to set temperature or heating too slowly? This thermostat controls oven temperature cycling. Test for continuity to diagnose the issue.

This metal rack fits inside the warming drawer beneath the oven, providing a flat surface to hold plates, dishes, or cooked food at a warm serving temperature. It slides in and out of the drawer on built-in guides. Replace it if the rack is bent, warped, rusted, or missing, which can prevent proper food placement and even heat distribution in the warming drawer.

Replace your range's control panel if the original is cracked, damaged, or showing wear. This panel mounts to the front and houses control components.

Range drawer glide with integrated ball bearings ensures smooth drawer operation. Replace when drawer sticks, won't close, or bearings are bent or damaged.

This is a flexible gasket that seals the gap around the main cooktop surface on a range or oven. It prevents heat from escaping and keeps grease, moisture, and debris from getting beneath the cooktop. Replace this gasket if you notice heat escaping from around the top, if the seal appears cracked, hardened, or no longer lies flat.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Rubber bumper that cushions your range door, reducing noise and preventing wear. Replace if cracked, missing, or worn to restore proper door contact.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Secures the oven door handle in place. Replace if screw is stripped, missing, or no longer holding the handle firmly against the door surface.

Washer that fits between the support roller and shaft in your dryer. Replace if worn, cracked, or missing to maintain proper drum alignment and support.