Parts for Kenmore 790.41012802 (79041012802, 790 41012802): Top / Drawer Parts

Range drawer panel that covers the storage compartment below the oven. Replace if your existing panel is cracked, dented, discolored, or missing.

Replaces cracked, broken, or damaged control panel trim on your range. This decorative panel covers the control area and restores a clean finish.

Replace your range's cracked or damaged control panel. This panel installs on the front of your electric range to cover and protect internal components.

Mounting bracket for electric and gas ranges. Secures components in place. Replace if bent, broken, or missing to restore proper structural support.

This 100W radiant element replaces a failed warming element to restore gentle, even heat in the appliance's warmer/drawer. It delivers low-profile radiant heat for keeping food warm between cooking and serving. What it does:

• Radiates low-level heat to maintain food temperature in the warmer or drawer
• Replaces a broken or non-heating warmer element
• Common symptom: warmer drawer not holding temperature or not heating
• Works as the heating element that sits under the warming surface to provide consistent warmth

• Disconnect power to the appliance before attempting service
• Inspect mounting and wiring; replace any damaged connectors or mounting hardware as needed
• Handle the element carefully to avoid bending or damaging the heating surface

Burner won't heat evenly or only outer ring works? This dual 9/12 inch radiant surface element restores proper heating. Easy DIY replacement in minutes.

Burner not heating? This 6-inch surface heating element restores cooktop function. DIY repair in 10-30 minutes with basic tools and simple instructions.

Replacement handle for electric ranges and wall ovens. Mounts to the oven door for easy opening and closing. Order now if your original is broken or cracked.

Secures the heating element to the cooktop surface. Replace if your original spring is broken, missing, or no longer holds the element firmly in place.

Replace your range's control panel if the original is cracked, damaged, or showing wear. This panel mounts to the front and houses control components.

Decorative finishing panel that covers exposed edges on your range for a clean appearance. Replaces cracked, broken, or missing trim to restore look.

Decorative trim piece that covers mounting edges on your range door or control panel. Replaces scratched, dented, or missing trim for a clean finish.

This wiring harness restores the appliance's factory electrical connections so controls and components can communicate and receive power. It replaces a damaged or worn harness to help return reliable operation. What it does:

• Routes power and signal connections between control modules and components
• Replaces frayed, cracked, or damaged wiring that can cause intermittent operation
• Can resolve component power loss or failure to start when the harness is the root cause
• Maintains correct connector fit and wire routing to prevent shorts or miswiring

• Disconnect power to the appliance before starting any repair
• Compare the harness and connectors to the original before installation
• Route wires following original clips and channels; avoid pinching or sharp edges

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Specs: 8 - 18 x 0.500

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

Washer that fits between the support roller and shaft in your dryer. Replace if worn, cracked, or missing to maintain proper drum alignment and support.