Trash Compactor Parts

Replacement washer for trash compactor assemblies. Installs between fasteners and components to distribute load and prevent damage. Order if worn or missing.

Frame roller assembly mounts to the compactor frame to support the sliding drawer. Replace if the roller is worn, cracked, or causing sticking movement.

If your compactor won't turn off or the switch stays on continuously, this off switch restores reliable power control. Takes about 5 minutes to install.

Compactor won't turn off or power down? This off-position switch restores reliable on/off control. Simple 2-minute repair fixes power control issues.

Replacement drive hub that secures the compactor's power screw to the transmission. Needed when the original hub is worn, cracked, or broken.

Fix a compactor that won't start or respond to buttons with this control board and touchpad assembly. Direct replacement part for common electronic failures.

This precision thrust race serves as the hardened bearing surface for axial loads in a rotating mechanism. Replacing a worn race reduces friction and noise, helping restore smooth, consistent motion and protect companion thrust bearings and washers from accelerated wear.

• Provides the hardened bearing surface for a thrust bearing assembly
• Supports axial load and helps maintain proper end-play in the mechanism
• Reduces friction to allow smoother rotation under load
• Wear may present as grinding/scraping noises, rough or binding motion, excessive axial play, or visible scoring

• Disconnect power and shut off water/gas before servicing
• Access the thrust-bearing area; note the order and orientation of races, bearings, and washers for reassembly
• Clean mating surfaces; replace any worn companion parts and lubricate only if specified by the service documentation
• Seat the new race fully and verify free movement by hand before reassembly and testing

Secures and supports internal compactor components to keep panels and assemblies aligned. Replaces worn, damaged, or missing brackets for firm installation.

Metal mounting bracket that secures internal components in your trash compactor. Replace if bent, damaged, or missing to restore stable part alignment.

Door strike plate for trash compactors. Mounts to cabinet frame to secure the door latch. Replace if cracked, bent, or missing to restore proper closure.

Replacement container liner for trash compactors. Installs inside cabinet-mounted units to hold compacted refuse. Replace if cracked, split, or worn.

Fix a compactor door that won't stay closed or latch properly with this door strike and catch. Restores secure door closure for safe operation.

Compactor won't run unless you hold the dial? A worn safety switch actuator prevents proper door latch engagement. This repair restores automatic operation.

This replacement insert restores the proper fit and finish of the appliance where a small trim or mounting piece is missing or damaged. It helps secure adjacent panels and prevents gaps or rattling for a cleaner, quieter cabinet. What it does

• Replaces a damaged or missing trim/mounting insert to restore fit and appearance
• Secures panels or components to reduce movement and rattling
• Helps maintain proper alignment of surrounding parts
• Addresses symptoms like visible gaps, loose trim, or vibration noises

• One insert

• Disconnect power before accessing panels or internal areas
• Remove the surrounding trim or panel to access the insert; basic hand tools may be required
• Handle carefully to avoid scratching finished surfaces; do not force parts into place
• Replace fasteners or clips to ensure a secure fit

Replace a scratched, bent, or loose compactor door handle to restore secure grip and finished appearance. Direct-fit part for easy installation.