Parts for Frigidaire FFTH102WA20: Unit Parts

This outer trim front panel restores the appliance's exterior look and protects internal controls and components from debris. It provides a finished appearance and helps keep the control area sealed from spills and splashes. What it does:

• Replaces a cracked, dented, faded or warped front trim that affects appearance
• Covers and protects underlying controls and electronic components from moisture and grime
• Helps the control area sit flush and align correctly with adjacent panels
• Prevents small objects from entering the control cavity

• One front panel / outer trim piece as shown

• Disconnect power to the appliance before starting any work
• Removal/installation typically requires removing nearby trim screws and gently prying clips; use appropriate hand tools
• Handle edges and painted surfaces carefully to avoid cuts or cosmetic damage
• Support components during removal to avoid stressing wiring or connectors

This door trim finishes the top edge of the appliance door, restoring a clean, finished appearance and covering the hinge/screw area. It helps maintain the door's look and protects internal edges from wear. What it does:

• Covers and protects the top edge and hinge/screw area of the door
• Restores a finished, factory appearance after damage or wear
• Prevents exposure of screws or trim gaps that collect dirt
• Helps keep the door edges aligned visually

• Remove power and open the door to access fasteners before replacing trim.
• Typical install uses screws or snap-fit tabs; keep original hardware unless replacement specified.
• Handle trim carefully to avoid scratching the finish during installation.
• Address hinge or door alignment issues separately; this trim covers cosmetic/edge areas only.

This replacement decorative trim restores the finished appearance around the appliance opening and covers exposed edges for a clean, factory look. It helps maintain a seamless exterior after damage or wear. What it does

• Covers and protects exposed edges on the appliance opening or control area
• Restores a finished, factory appearance for cosmetic damage like chips or cracks
• Prevents dirt and debris from collecting in gaps along the edge
• Useful when original trim is dented, warped, or missing

• Disconnect power to the appliance before starting any service.
• This is a cosmetic trim; remove adjacent panels or screws as needed to access mounting points.
• Use appropriate hand tools (screwdriver, trim tool) and work carefully to avoid scratching surrounding surfaces.
• Refer to the appliance owner's manual or service guide for disassembly steps and mounting locations.