Parts for Frigidaire FFTH1422R22: Unit Parts

This air filter screens the air moving through your appliance's ventilation system, capturing odors and fine particles. Replacing a clogged or damaged filter helps maintain proper airflow so the unit vents and circulates air as designed. What it does:

• Captures odors and airborne particles as air passes through the unit
• Helps maintain proper airflow/venting performance
• Reduces debris buildup on internal components
• Common signs it's due: persistent odors, reduced airflow/venting, a visibly dirty or damaged filter

• 1 air filter

• Disconnect power and allow hot surfaces to cool before servicing
• Open the filter access panel or grille and note the filter's orientation
• Remove the old filter; seat the new filter fully and close the cover
• Restore power and verify proper airflow

The Heater is an OEM part for Frigidaire air conditioners. Designed to provide supplemental heating, this heater extends the usability of your air conditioning unit into the colder months, enabling both cooling and heating from a single appliance. 

Causes of a bad heater can include electrical faults like short circuits or failing elements, accumulation of dust or debris that impedes functionality, and general wear and tear that deteriorates its components over time.

Symptoms of a bad heater include:

• Reduced heating efficiency, failing to adequately warm the space
• Circuit breaker trips when the heater is turned on
• Unusual or loud noises during operation
• Smell of burning when the heater is active

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This water inlet valve controls water flow to the refrigerator's ice maker and dispenser, restoring reliable water delivery when the valve is functioning properly. It replaces a failing inlet valve to stop leaks and restore dispensing and ice filling. What it does:

• Opens and closes to allow water into the ice maker and dispenser when commanded
• Stops water flow to prevent overfilling and leaks when closed
• Commonly found when the dispenser or ice maker won't fill or water flow is weak
• Can leak or drip when the valve diaphragms or seals fail
• Works with the refrigerator's water supply and control signals

• Turn off power and shut off the water supply before starting any repair
• Inspect inlet hoses and fittings for damage; replace damaged hoses to prevent leaks
• Use basic hand tools; avoid overtightening fittings which can cause leaks

This fastener kit supplies the assorted screws and clips used to secure panels and components on compatible Frigidaire appliances, helping restore proper fit and stop loose or rattling parts. Ideal for repairs where original mounting hardware is missing or damaged. What it does:

• Replaces worn, missing or damaged mounting hardware so panels, brackets and trim stay secure
• Helps eliminate vibration noise and loose-fitting parts that cause rattling
• Restores correct alignment for doors, panels or internal assemblies that use small fasteners
• Provides the specific fasteners needed for the factory-replacement process

• Basic hand tools (screwdrivers, nut drivers) are typically required; refer to your model's service manual for exact fastener locations and torque
• Turn off power and disconnect the appliance before starting any repair to avoid shock or injury
• Handle small parts carefully and keep them away from children and pets

This replacement tube routes meltwater away from the freezer compartment to the drain pan, helping prevent pooling and ice buildup. It restores proper defrost drainage to reduce odors and water leaks. What it does:

• Guides defrost and condensation water from the evaporator area to the drain system
• Helps prevent water pooling inside the freezer or refrigerator compartment
• Reduces ice buildup around the evaporator by keeping the drain clear
• Common symptom fix: stops intermittent leaks, dripping, or standing water after defrost cycles

• One replacement drain/defrost tube

• Disconnect power to the appliance and shut off the water supply (if applicable) before starting
• Remove shelves, panels, or the evaporator cover as needed to access the tube
• Secure connections; replace any damaged clips or grommets

The Thermistor is an OEM replacement part for Frigidaire room air conditioners. Located within the air conditioner unit, the thermistor accurately monitors and regulates the equipment's internal air temperature. Precisely calibrated at the factory, the thermistor allows the unit to continuously achieve and maintain the preset cooling level preferred by the user. 

Symptoms of a bad thermistor include:  

• Inconsistent or fluctuating room temperatures
• Difficulty reaching or maintaining desired temperatures  
• The control panel shows abnormal temperature readings

Causes can be age-related deterioration of sensing components, moisture exposure damaging circuitry, or loose wiring connections preventing exact temperature measurement over time. This OEM thermistor restores precise temperature control.

Replacing a faulty thermistor prevents improper compressor cycling which wastes energy. Compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

A handheld replacement remote control that restores convenient, wireless operation of your appliance's basic functions. Use it to power the unit on/off and change settings from across the room without touching the control panel. What it does:

• Sends wireless commands to the appliance to control power, temperature, fan speed, and mode selection.
• Replaces a lost, damaged, or unresponsive remote to regain full remote operation.
• Uses standard batteries.

• Insert fresh batteries before first use and follow the appliance's pairing or sync procedure if required.
• Keep remote dry and avoid dropping; do not attempt to open or service the remote—replace if internal damage is suspected.
• Dispose of batteries properly and remove batteries if storing the remote for extended periods.