Parts for Gladiator GARF30FDGB01: Unit Parts

This wire harness is an electrical assembly that connects components and routes power and signals inside the appliance, restoring reliable electrical connections and component communication. What it does:

• Re-establishes electrical connections between internal components and control circuits
• Restores power or signal paths that can cause intermittent operation or non-functioning parts
• Prevents loose or damaged wires from shorting or causing erratic appliance behavior
• Helps ensure secure, organized wiring routing and proper connector fit

• One assembled wire harness as shown

• Disconnect power to the appliance before inspecting or replacing the harness
• Take reference photos of the existing harness routing and connector positions before removal
• Plug connectors in fully and secure any routing clips or tie points to prevent chafing
• If wiring shows heat damage or exposed conductors, replace affected components and follow OEM service instructions

This evaporator wire harness routes power and signals to the freezer evaporator components so the cooling and defrost systems operate correctly. It replaces a damaged or disconnected harness to restore circuit connections behind the evaporator. What it does:

• Provides electrical connections to evaporator components such as the defrost heater, thermostat/thermistor, and fan motor
• Ensures consistent signaling for defrost cycles and evaporator fan operation
• Helps stop symptoms like a warm freezer, intermittent cooling, or failed defrost when caused by wiring faults
• Maintains proper routing and secure connector fit to prevent shorts or intermittent contacts

• One evaporator wire harness assembly

• Disconnect power to the appliance before starting any repair
• Remove evaporator cover panels carefully; avoid bending evaporator fins
• Match connector shapes and routing to the original harness; secure away from moving parts

The Start Device is an OEM component specifically designed for Whirlpool refrigerators. It initiates compressor and condenser functions at startup to begin cooling cycles. This includes relays between temperature sensors, thermostat contacts, and electrical power feeds.

Symptoms of a faulty start device include:

• The refrigerator failing to maintain proper temperatures 
• Abnormal buzzing or humming noises emanating from inside
• Lights or fans running without associated cooling 

Causes can be related to the usual wear of electrical contacts or voltage drops over extended use.

Replacing the start device with this genuine OEM part helps keep cooling functionality dependable. This Whirlpool replacement part is compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models. 

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

This genuine replacement screw secures panels and components so your appliance stays stable and trim pieces fit properly. It's a simple, exact-fit fastener intended to replace a missing or damaged mounting screw. What it does:

• Fastens panels, trim, control housings or brackets to the appliance frame
• Restores secure fit when a screw is missing, stripped, or corroded
• Helps eliminate rattling or loose panels caused by a missing fastener
• Matches OEM thread and head style for correct seating and torque

• Use the correct screwdriver or bit to avoid stripping the head
• Do not overtighten; snug until parts are firmly seated
• Disconnect power and follow appliance safety guidelines before servicing