Parts for Whirlpool WRT318FMDB02: 06 - Unit Parts

Freezer icing up or frost building on coils? The defrost heater melts ice from evaporator coils. Moderately difficult repair, about 1 hour install time.

Refrigerator not cooling or freezing over? The evaporator coil removes heat from compartments. Fixes cooling loss and frost buildup issues in your fridge.

Screw: 8-16 x 3/8 inch.

This is a metal heat shield designed to protect internal components from excessive heat inside the refrigerator or freezer compartment. It acts as a thermal barrier, typically installed near the defrost heater or compressor area, preventing heat damage to surrounding parts. Replace this shield if it is warped, corroded, or missing, which can lead to uneven cooling or frost buildup.

Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.

Control panel buttons not responding? This wire harness connects your touch interface to the main control board, restoring reliable button response.

Fix uneven cooling or warm spots in your refrigerator with this air baffle. Directs airflow between compartments to restore temperature balance. Easy DIY fix.

Rubber grommet kit that mounts and cushions the compressor. Replace worn, cracked, or damaged grommets to restore proper support and isolation.

Fix a refrigerator that won't cool or won't start. The compressor start device provides the electrical boost to start the compressor. DIY-friendly repair.

Secures panels, hoses, and wiring in place to prevent rattling and loose components. Replace when worn or broken to restore proper fit. Confirm compatibility with your model number.

This refrigerator roller supports the unit's weight and enables smooth movement for positioning and cleaning. Replace when wheels crack or roll roughly.

Cabinet roller axle supports refrigerator wheels for smooth movement. Replace if rollers wobble or fridge is hard to move. Verify fit with your model.

Mounting bracket for refrigerators. Installs internally to secure components in place. Replace if bent, cracked, or missing to restore proper support.

Replaces stripped, missing, or damaged mounting screws that secure panels, brackets, and components in your refrigerator. Restores proper assembly.

Fix a refrigerator that's not cooling properly with this condenser fan motor. Replaces worn motors causing poor heat exchange. Video guide included.

Size: 8-18 x 1/2 inch.

This is the fan blade that attaches to the condenser fan motor, typically located near the bottom rear of the refrigerator. It draws air across the condenser coils to dissipate heat and keep the refrigerator running efficiently. Replace this blade if it is cracked, warped, or broken, which can cause loud noises, reduced cooling performance, or the compressor overheating.

Extension component for top-mount refrigerators. Replaces cracked, broken, or missing extension pieces. Direct fit for compatible models.

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

Drain tube that routes defrost water from the evaporator to the drain pan. Replace if cracked, clogged, or disconnected to prevent water leaks.

Replacement clip for your refrigerator. This small fastening component secures interior parts in place. Order a new one if yours is broken or missing.

Size: 1/2 inch.

Size: 5/8 inch.

Size: 3/4 inch.

Size: 3/16 inch.

Size: 5/16 inch.

Size: 3/8 inch.

Size: 1/4 inch.