Parts for Ge JGB870DET3BB: Upper Door Parts

Includes 12 speed nuts.

Color: Black

This replacement door bracket secures the appliance door to the cabinet so the door opens and closes smoothly and stays properly aligned. It restores correct door support and helps prevent sagging or binding. What it does:

• Supports and anchors the door to the cabinet or hinge assembly
• Restores proper door alignment to help ensure a tight, even seal
• Reduces door sag, uneven closing, or binding during operation
• Works with original hinge/mount points to maintain factory fit

• Disconnect power and, if applicable, shut off gas and water before starting work
• Use basic hand tools; keep fasteners and any small parts organized for reassembly
• Handle doors and edges carefully — door glass and trim can be fragile and sharp
• If door alignment issues persist after installation, check hinge wear and mounting hardware for additional damage

This silicon controlled rectifier (SCR 8-22) is a replacement power-switching semiconductor used in appliance control and ignition circuits to help control current flow for heating and ignition components. Installing the correct SCR restores reliable switching and can stop intermittent or complete loss of heater/igniter function. What it does:

• Acts as a high-current electronic switch that controls power to heating or ignition elements when driven by the appliance control board
• Replaces a failed SCR to resolve symptoms like no ignition, no heating, intermittent power to elements, or control board error codes related to switching
• Works as part of the appliance's control/ignition circuit to ensure timed, controlled delivery of current
• Matches common OEM/catalog designation "SCR 8-22" for direct replacement where specified

• One SCR 8-22 replacement semiconductor

• High-level replacement only: follow the appliance service manual for location and wiring; ensure correct orientation and connector fit
• Disconnect power at the breaker and confirm no line voltage before servicing
• Handle the SCR and surrounding electronics carefully to avoid ESD damage; use proper grounding