Parts for Ge ZET1058BF3BB: 04 - Upper Oven Parts

This is a replacement trim piece that fits around the oven bake element to restore a finished appearance and help secure the element assembly. It replaces a damaged, bent or missing trim so the element mounts cleanly and safely. What it does

• Provides a finished trim around the bake element opening to restore oven appearance
• Helps hold the bake element in its proper position and alignment
• Covers gaps or sharp metal edges left by a damaged or missing trim
• Common symptom: visible damage, missing trim, rough or sharp edges around the element area

• One replacement bake element trim

• Disconnect power to the range before any service to avoid electrical shock
• Access typically requires lowering or removing the oven door and pulling the oven cavity forward; keep track of fasteners
• Handle metal trim carefully to avoid cuts; use gloves as needed
• If the bake element is loose or damaged, inspect the element and mounting hardware and replace separately if required

This ring-style convection heating element mounts around the fan at the back of the oven and supplies heat for convection cooking. Replacing a failed element helps bring back even air heating and consistent convection bake performance.

• Provides the heat source for convection bake/roast by warming air circulated by the fan
• Helps maintain set temperature and more even results in convection mode
• Common failure signs: no heat in convection while the fan runs, slow or incomplete preheating, uneven baking, visible breaks/blisters, or an open circuit on a continuity test
• Designed to cycle under control of the oven's sensor and electronic controls

• Disconnect power at the breaker or unplug the appliance before servicing
• Access may be from the rear of the appliance or by removing the interior panel over the convection fan, depending on the model
• Label and support the two element leads to keep them from retracting into the cavity; ensure terminals are fully seated
• Reuse existing mounting hardware; avoid bending the new element and verify it doesn't contact the oven cavity

Cooling fan assembly circulates air to remove heat from the appliance's condenser and electronics. Replacing a failing cooling fan restores airflow, helps prevent overheating, and improves overall cooling performance. What it does:

• Moves air across condenser/compressor and internal components to dissipate heat and support proper cooling.
• If the motor or blade fails, common symptoms include no airflow or intermittent operation.
• Worn bearings, debris, or damage can cause loud grinding, rattling, or unusual noise during operation.
• A working cooling fan helps the appliance run on normal cycles and reduces excessive run time caused by poor heat removal.

• Disconnect power before starting — always unplug or switch off the breaker to avoid electric shock.
• Handle sheet metal edges and components carefully; wear gloves to prevent cuts.
• Note connector orientation, wiring, and mounting screw locations during removal for correct reinstallation.
• After install, restore power and verify fan runs quietly and provides steady airflow.

This halogen light bulb restores bright, reliable illumination inside your appliance, making it easier to check food and read controls. Replace a burned-out or broken lamp to bring back safe, convenient visibility while cooking.

• Provides bright lighting for the appliance cavity or work area
• Direct replacement for a failed, flickering, or shattered bulb
• Helps you monitor cooking progress without opening the door
• Typical symptoms: light won't turn on, intermittent flicker, blackened or broken glass

• Disconnect power by unplugging the unit or switching off the circuit breaker before servicing
• Allow the light area and lens to cool completely
• Handle halogen bulbs with a clean cloth or gloves; avoid touching the glass
• Install per your appliance's instructions and ensure the bulb is fully seated and any cover is secured