Parts for Bosch NGT746UC/01: Valve Assembly Parts

This push-on retainer clip holds a 6mm shaft securely in place on compatible appliance components, restoring proper axial restraint and preventing parts from sliding off during operation. Simple, low-profile fastening for shaft retainment. What it does:

• Secures shafts and spindles with a 6mm outer diameter to prevent axial movement
• Keeps knobs, pulleys, or rotating components positioned correctly during use
• Commonly used where a quick, tool-free clip is required for retention
• Can resolve symptoms like loose or detached knobs, wobbling pulleys, or parts sliding along the shaft

• One push-on retainer clip sized for 6mm shaft mounting

• Push the clip onto the shaft groove until it snaps into place; ensure full engagement before operating
• Use snap-ring pliers or appropriate tools if removal is required to avoid damage
• Wear eye protection when installing or removing clips to guard against sudden release

The Spark Switch is an OEM part for Bosch ranges. This part ignites the burners by sending a signal to the spark module, which then produces the spark needed to ignite the gas.  

Causes of a bad spark switch can include wear and tear from regular use, damage from spills or cleaning agents, or electrical issues.  

Symptoms of a bad spark switch include:

• Burners not igniting
  Continuous clicking even after the knob is turned off
  No spark when attempting to ignite the burner
  The cooktop not producing a flame

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

This is a replacement gas tubing assembly for your gas range that routes fuel safely between the valve and burner manifold. Replacing damaged tubing restores proper gas flow and helps eliminate leaks or ignition problems. What it does

• Routes gas from the range's valve to the burner manifold or secondary fittings
• Restores proper fuel flow when old tubing is cracked, corroded, or pinched
• Addresses common symptoms like a gas smell near the appliance, burners that won't light, or visible tubing damage
• Serves as a direct-fit OEM-style replacement when the original tubing is worn or leaking

• One gas tubing assembly

• Turn off the appliance gas supply and power before inspecting or replacing tubing
• Only install with compatible fittings and thread sealant rated for gas connections; follow manufacturer torque specs
• After installation, perform a certified gas-leak test and check all burner operations