Parts for Thermador UCV245DS: Vent System Parts

This cover is a molded trim piece that restores the appliance's finished appearance and protects underlying components from dirt and damage. It replaces broken or missing covers to improve safety and maintain proper operation. What it does:

• Conceals and protects internal components behind the appliance cabinet or control area
• Prevents debris buildup and accidental contact with exposed parts
• Restores the original cosmetic appearance where the cover was damaged or missing
• Common symptom: cracked, broken or missing cover leaving components exposed

• One replacement cover as shown

• Disconnect power (unplug or switch off breaker) before beginning any work
• Installation typically requires removing adjacent trim or a few screws; keep hardware for reassembly
• Handle carefully to avoid scratching the finish and ensure clips/tabs fully engage

Fix a range hood that won't turn on or respond to controls with this switch replacement. Common for fan or light control failures. Basic repair.

Stress relief component for downdraft ventilation systems and range hoods. Replaces worn, damaged, or missing parts during installation or repair.

This is an interlock switch used in a range hood ventilation system. It acts as a safety mechanism that controls power to the hood's motor or lighting based on the position of a panel or filter. Replace this switch if the hood fan or light fails to turn on or off properly, or if the switch no longer clicks into position when the filter or access panel is engaged.

Mounting bracket for downdraft ventilation systems. Secures the unit to cabinetry or countertop. Replace if bent, cracked, or missing hardware slots.

Fix ventilation control issues with this downdraft cable harness. Restores power to blower motors and controls. Direct replacement for most systems.

Replacement mounting bracket for downdraft ventilation systems. Secures panels and components for proper alignment. Replaces damaged, cracked, or missing brackets.

Flat metal washer for downdraft ventilation systems and range hoods. Replaces lost, corroded, or damaged washers during assembly or repair work.

Sleeve component for downdraft ventilation systems and range hoods. Replaces damaged, cracked, or missing sleeves during installation or repair work.

Flexible sealing strip creates a tight closure along your downdraft vent door edge to prevent air leaks and maintain efficiency. Replace when worn or damaged.

Internal protective sheet for downdraft ventilation systems. Replaces torn, missing, or damaged panels that shield wiring and components inside your unit.

Spring guide that attaches to the cushion spring bracket in downdraft ventilation systems. Replace if cracked, broken, or missing to secure the spring.

Fixes downdraft range hood lights or fan not working. This transformer converts voltage for proper lighting and ventilation operation. Moderate DIY repair.