Warming Drawer Parts

This snap bushing is a push-in panel grommet that protects and secures wiring where harnesses pass through metal or plastic panels. It prevents chafing and helps keep wire routing neat for safer operation. What it does:

• Cushions and shields wires from sharp panel edges to reduce abrasion and shorts
• Secures wiring harnesses in place to prevent unwanted movement or snagging
• Provides a finished, vibration-resistant pass-through for electrical leads
• Commonly replaced when the original bushing is cracked, broken, or missing

• One snap bushing

• Disconnect power before servicing electrical components
• Press-fit into the panel hole until the bushing snaps into place; confirm a secure fit
• Replace if brittle, torn, or deformed; do not use a damaged bushing
• Use pliers for removal if needed; avoid forcing or enlarging the hole

This warming drawer insert restores the removable drawer that keeps cooked food warm until serving. It replaces the drawer component for select built-in warming drawers to return proper fit and function. What it does:

• Provides the removable inner drawer used to hold and retrieve warmed dishes
• Re-establishes correct drawer fit and sliding function in the warming drawer cavity
• Helps maintain heated food placement while the drawer is closed
• Addresses symptoms like a missing, damaged, or ill-fitting drawer insert

• One warming drawer insert

• Turn off power to the appliance before servicing and allow surfaces to cool
• Remove existing drawer per manufacturer instructions before installing the replacement
• Align drawer slides and guide rails, then slide fully into place to confirm proper fit

Bottom cover panel for 27" warming drawers. Replaces damaged, cracked, or missing bottom housing. Restores appearance and structural integrity.

Secures burner or oven control to the control panel behind the knob. Replace if stripped, missing, or loose to keep control shaft stable and aligned.

This is a stainless steel oven door handle that mounts to the front of the range door. It provides a grip for opening and closing the oven door during use. Replace this handle if it is cracked, broken, loose, or if the mounting points have become stripped or damaged.

Warming drawer door gasket seals the door to maintain consistent temperature. Replace if torn, cracked, or heat escapes. Verify fit with your model number.

Machine screw for securing oven panels, brackets, and internal components. Replace missing, stripped, or damaged screws during repairs or reassembly.

This 6/32 hex nut secures components on your cooktop, range, or oven. Replace missing, stripped, or corroded nuts during repairs or maintenance.

This is a front panel frame for a 27-inch warming drawer, finished in black. It serves as the outer decorative and structural frame surrounding the warming drawer's front face. Replace this panel if it is cracked, scratched, discolored, or if the frame is warped and no longer sits flush with the surrounding cabinetry.

Warming drawer not heating or taking too long to warm up? This heating element restores gentle heating to hold food at serving temperature. DIY repair.

Replacement handle for range oven doors. Mounts to the front exterior of the door for opening and closing. Replace if cracked, broken, or loose.

Range won't heat or overheats? This safety thermostat protects against excessive temperatures. Direct replacement part for reliable operation.

Mounting screw secures heating element to cooktop surface. Replace if stripped, rusted, or missing to ensure proper element installation and stability.