Parts for Frigidaire 6208A: Washer Top Load Page 4 Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This removable cup holds liquid fabric softener and releases it during the rinse cycle of the wash. Located in the washer's dispenser drawer or agitator, it should be replaced when fabric softener doesn't dispense properly, the cup is cracked, or softener residue cannot be cleaned away.

Washer tub ring that mounts around the outer drum assembly. Replace this structural component if it's cracked, broken, or damaged during repairs.

This replacement bolt secures internal components in your appliance. A stripped, rusted, or missing bolt can let parts loosen and vibrate; installing a new bolt restores a tight, stable connection for reliable operation.

• Provides a secure, threaded fastener for brackets, weights, or assemblies
• Helps maintain alignment and reduce movement during operation
• Typical issues: missing hardware, stripped threads, or visible corrosion
• Helps address rattling or excessive vibration caused by loose hardware

• Safety first: Disconnect power; for water- or gas-connected units, shut off supplies
• Support the component being secured before removing the old fastener
• Start threads by hand to avoid cross-threading; tighten evenly to manufacturer guidance—do not overtighten
• Reuse original washers/spacers and thread locker only if they were originally present

Structural component that supports the washer drum assembly. Replace if cracked, broken, or showing wear that causes drum instability or movement issues.

Secures the washer's inner basket to the drive hub, keeping the tub centered and stable during spin. Replace if cracked, corroded, or bolts are damaged.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This is a threaded leveling leg assembly that screws into the base of a washing machine. It allows you to adjust the height at each corner to keep the appliance stable and level on the floor. Replace this part if the leg is stripped, broken, or if your washer vibrates excessively or walks across the floor during the spin cycle.

This part has been discontinued by the manufacturer and is no longer available.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.