Whirlpool Cooktop Housing Or Cover

This OEM part is a griddle cover made for stoves. A griddle cover is a metal piece that can be placed over the stove's burners to be used as a cooking surface. If a griddle cover becomes damaged due to excessive use, it can become ineffective and need to be replaced. Luckily replacing a griddle cover is a very simple process.To replace the griddle cover, make sure the stove is unplugged. Being by lifting the old cover out of its place by pushing it forward and lifting upward to release it from its attachment on the stove. Once removed set it off to the side. Next, proceed to take the new cover and place it back where the old one was while making sure it locks into its attachment. Once secured, turn the power back on to the appliance.This genuine replacement part is sold individually and is compatible with Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Sears/Kenmore brand stoves.

This wire cover is a protective sleeve that helps route and shield appliance wiring to reduce wear and prevent accidental contact. It restores a neater harness run and helps maintain safe electrical routing inside the appliance. What it does:

• Protects wires from abrasion and chafing against sharp edges or moving parts
• Helps prevent exposed conductors that can cause shorts, arcing, or burning smells
• Keeps wiring bundled and routed to reduce pinching and stress on connectors
• Reduces risk of intermittent electrical issues caused by damaged insulation

• Disconnect power before beginning any service to avoid shock or injury
• Inspect surrounding wiring and connectors for damage; replace any frayed or exposed wires
• Slide cover over the wiring harness or route harness through sleeve as needed; secure with existing clips or approved fasteners

This replacement console end cap restores the appliance's finished look and protects internal controls from dust and debris. It fits where the original console cover has cracked, warped, or broken to help maintain safe operation and appearance. What it does:

• Replaces a cracked or damaged console end cap that exposes controls or wiring
• Shields control components from dust, moisture, and everyday wear
• Helps prevent snagging or cuts from sharp broken edges on the console
• Restores a secure, finished fit for the console area

• One console end cap / cover

• Remove power to the appliance before starting any repair to avoid shock
• Handle the cover gently to avoid breaking tabs; use proper trim tools if needed
• Verify clip alignment and engage all retaining tabs fully for a secure fit
• If hardware is corroded or missing, replace with OEM fasteners