Mark D Milan , NH November 23, 2019 Appliance: Kenmore Undercounter Diswasher 66512093K210 Leaked water onto diverter motor(bottom center) Replaced sump because the seal is not sold separately. You will need a skinny clamp after cutting the original swaged clamp off. Also Had to replace the cover as its seal is not sold separately either. Used dish soap on seals during assembly. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers
George R Ho-Ho-Kus , NJ January 11, 2024 Low water pressure . Fixed the gasket that was broken and allowing water to leak out from the diverter cover. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Elizabeth F Norfolk , VA October 25, 2024 Water leaking Replaced sump seal. Water dripping down diverter stem. This seal is part of sump seal. Since you have to remove all parts from seal, replaced all rubber seals that I could. Everything was aged, so why not while your under unit anyway. Replaced diverter motor also since water was dripping onto it. I used o ring grease instead of water, to help installing. WATCH the videos!!! Step by step and very helpful. They show a few tricks that will aid in the install. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers
Glen L Belvidere , NJ October 30, 2020 Dishes in lower rack were not getting clean. Inspected parts and found that 2 locking tabs on the sump cover were cracked and rubber ring was worn out. I replaced the sump cover and also replaced the lower spray arm to ensure I resolved the issue. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Aaron N Beaverton , OR January 26, 2025 My water diverter broke Ordered a new one and replaced the broken one with it. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes