Whirlpool WP74010750 Electric Range Oven Bake Element OEM Part

I finally found the right serial number and found the part at Appliance Parts Pros. I was skeptical that they would send the element that had the correct rear brace fixture. when it came 2 days later i opened the box the Part was correct and it took about 15 minutes to replace since there are only two screws. My oven works fine now. THX

Very easy fix. Remove oven door by just opening it slightly and pulling up. (an easy way to clean it too). Then, with a phillips screw driver, remove two screws holding the damaged element in place. Slowly pull the element toward the front a couple inched to expose the wires. Disconnect the wires (no tools needed), remove the old element and replace it with the new. Reverse the past few steps and re-attach the wires and screw. Simple as that. I also chose to replace the Broiler Element as a precautionary measure following essentially the same procedure (a few more screws). The oven door gasket was old and leaking, so it was also replaced as well. No tools require.

Replacing the heating element was just the ticket.

Unscrewed parts of element left in tact in rear of oven and removed clips on elements end. Installed clips on new element and pushed into hole in rear of oven. Then screwed retaking clips into oven rear wall. Fifteen minute job and all worked well

Called from Michigan on Monday about 3:30 p.m. Had the part by noon on Tuesday and by 3:30 had baked 4 dozen cookies - coil just had to be pulled out and the new one put in - took maybe 5 minutes. Great service!