Whirlpool W10823722 Range Surface Radiant Element OEM Part

I ordered a new burner and switch. Received all parts in only one day. Shut breaker, pulled out the range to work on it. Removed the front panel to replace the switch first which was the easy part of the job, only 6 screws. Installed new switch, turned on the breaker to test and found that the burner heated up proving that only the switch was bad. Shut breaker again, reinstalled front panel, reinstalled the range and turned the breaker back on. Just in time for Easter dinner! Returning unused new burner to Appliance Parts Pros.

Disconnect power removed 8 screws to remove glass cooktop, disconnected three wiring harnesses. Swapped burner. Two screws and two connections on back of switch. Replaced everything. Success.

I replaced the convection fan assembly. It is removed from inside the oven and consists of the fan and a heating element. Disassembly was easy, just remove the oven door, a sheet metal cover, then the fan assembly, unplug the fan's one wy plug and the two leads to the heating element. The only issue on reassembly was plugging the leads back onto the heating element. The leads are a little too short to assemble from inside the oven. I was able to do it by having a second person help. Those leads are obviously designed to be attached after the fan assembly is screwed into place, but that would require pulling the stove out of the cabinet and accessing from the rear rather than from inside the oven. Remember to shut off the power before this job

The replacement burner worked for my Jenn-Air range, but I could not use the screws to attach the factory clips (holes were not drilled in same place as original part). I had to jerryrig the clips to work...not a big deal.