Whirlpool WP89503 Washer Fill Hose OEM Part

Replaced flow meter and control valve

1) Close hot/cold water supply spigots. 2) Using a thin screwdriver or putty knife, open the machine lid by popping the 2 latches in the front seam, about 3-inches in from the corners. 3) Detached water inlet valve from the wire harness and front/back covers. Total of 3 screws (nut driver) and one tab (gently pry up with a small screwdriver or similar). 4) With the valve free of the machine, note the position of each fill hose and detach the hoses (slip-joint pliers). 5) Attached fill hoses to the new valve and reassemble machine in reverse order. 6) Open water supply spigots and test machine for correct water inlet control and temperature. (5-stars to AppliancePartsPros - extremely easy parts look-up, fair price, and fast delivery)

Took off old hoses and put on new ones. No problem.

I replaced the drain pump and the drain hose. The machine is working so much better! Don't get the rubber hoses. Get steel braided. Preferably the hose has a 90 degree bend. There are also ones with a safety stop in case the hose breaks.

Replaced drain hose, the first hanger was broken and rubbing on the floor. It wore a hole in the hose! Easy replacement with a pair of pliers!