Tamara M Saint Charles , MO July 16, 2016 Appliance: Model KENMORE SIDE-BYSIDE REFRIGERATOR Exterior ice & water dispenser parts we discolored mainly due to lime scale Even though the refrigerator is 13 years old, I was able to find replacement parts on your site. The DIY video provided on-line for each of the four parts ordered was very helpful ; even though my refrigerator wasn't exactly like the one in the video, it was still helpful. I'm not usually the DIY type- but with your help the repair was very successful! Thank you ! Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Kent M Hamlin , NY February 22, 2020 Water not dispensing and arm wasn't responding. Researching found lever retainer was broken. Replaced level and lever retainer. Arm now responds. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Socket Set
Roger S Santa Maria , CA July 11, 2016 Appliance: Whirlpool Refrigerator GS6SHEXNL00 My refrigerator water dispenser leaked intermittently I replaced the water inlet valve & both dispenser levers (water & ice) and adjusted the lever locking spring. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Randall M Las Vegas , NV September 20, 2015 Appliance: Whirlpool Refrigerator GS6SHAXML00 Calcium deposits on the water and ice levers Bought new and replaced. installation was pretty easy following the video for most but not exactly as model I have. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
John B Fort Wayne , IN January 05, 2016 Water deposits on ice and water levers Removed: the overflow grill by pressing it to me, lifted up the software and removed the tape holding it in place so it will go higher and even higher by pulling the wire from the refregerator about 1/2 inch, removed the screw the holds both ice and water levers, removed the ice guide, removed the ice door hinge, then the final road block was gone to remove the ice door lever. Plastic clips need just a little help to get them uncoupled with a small small screw driver. Just think somebody made this in a factory and you can take it apart, just think it through. Put everything back in order of what I took out last. Save at least $100 labor charge for this project. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers