Earl S Cannon Falls , MN July 11, 2018 Appliance: Model KITCHENAID KP26M1XER 6 QT MIXER Badly worn drive gear mixer wouldn't turn Opened the mixer and found which parts were bad and needed. Found your site via google. Found the needed parts on your site. Ordered parts and installed them. Wife happy. end of story. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers, Socket Set, Wrench Set
Roslyn D Chesterton , IN October 25, 2019 Burned out motor The videos from appliance parts pros are great it took 5 minutes to fix my wife's Kitchenaid mixer. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Ryan P Valencia , PA January 12, 2022 KitchenAid 600 mixer not powering up when turned on. The mixer let out a puff of smoke when turned off after 7 minutes of kneading bread. There were no burnt wires or electrical connections I could see. Assumed it was the motor vs. the control board. All it took was a Phillips head screwdriver to take the mixer apart and install the new motor. I think there were a total of 15 screws to disassemble. I could have reused the motor shaft seal, but glad I ordered a replacement just in case. Wish I would have had some grease on hand to apply to the drive shaft. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Dick E Powers Lake , ND April 04, 2019 Drive gears worn and jumping teeth Replaced motor (armature shaft worn). Replaced counter shaft and associated bearings. Replaced grease. Added benefit: Reduced noise by 50%... Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Michael D Clinton , AR January 06, 2022 Noisy. Not working right. Replace bearings etc. Only one part didn’t fit so I used the old. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers