Whirlpool Washer Dryer Combo Parts

Secures shafts and pulleys in your washer to prevent axial movement. Replace when worn or damaged to restore proper alignment. Confirm fit with model.

Replacement mounting nut for dishwashers, washers, and laundry appliances. Secures components by threading onto studs or bolts. Replace if stripped, rusted, or missing.

The dryer grounding clip is a small metal fastener that maintains a secure electrical ground connection between components inside your dryer. A proper ground is essential for safe operation and helps protect against electrical shock or appliance damage. Replace this part if it is bent, corroded, or missing, especially if you are experiencing intermittent electrical issues or completing a repair that requires re-grounding internal parts.

Connects the drain hose to the washer drain outlet. Replace this coupling kit if cracked, broken, or leaking to restore a secure connection.

Left-side door hinge for laundry center appliances. Restores proper door support and alignment. Replace if hinge is bent, cracked, or worn.

Replace your washer dryer combo's worn, cracked, or missing control knob. This biscuit-colored knob installs on the control panel shaft for cycle selection.

This drum hole plug seals an unused or service access hole in the dryer drum to help prevent clothing snags and reduce interior airflow leaks. Simple replacement restores the drum surface and helps keep items from catching. What it does:

• Covers a drum access/service hole to provide a smooth interior surface
• Prevents fabric from catching or tearing on open drum holes
• Reduces unwanted air leakage through the drum
• Helps maintain normal drum rotation contact points by keeping openings closed

• One drum hole plug

• Disconnect power to the appliance before starting any repairs
• Inspect the drum area and remove any debris before installing the plug
• Press or snap the plug into the hole until fully seated; replace if damaged or deformed

Mounting bracket for laundry center units. Secures components in proper position. Replace if bracket is bent, cracked, or broken during installation.

Fix a washer that won't spin or agitate with grinding noises. This transmission gearcase assembly transfers motor power to drive the wash basket.

The dryer toe panel spacer provides proper alignment and spacing for the front bottom panel of the dryer. Replace when the toe panel is loose, misaligned, or there are visible gaps at the bottom of the dryer.

Hex nut that secures fasteners on washer and dryer panels, brackets, and components. Replace if stripped, rusted, or missing to restore proper fit.

This bearing supports the spin basket (inner tub) in top-load washers, allowing it to rotate smoothly during the spin cycle. It is mounted at the base of the spin basket and bears the load of the drum and its contents. Replace this bearing if the washer makes loud grinding or squealing noises during the spin cycle, if the basket wobbles excessively, or if you notice water leaking from beneath the tub.

White plastic plug insert for dryer side panels. Fills mounting holes for a clean finish. Replace if cracked, broken, or missing from installation.

This is a small rubber or plastic bumper that attaches to the console area of an ice machine. It acts as a cushion to prevent vibration noise and protect surfaces from impact during operation. Replace this bumper if it is cracked, missing, or deteriorated, which can cause rattling sounds or allow the console to shift out of position.