Parts for Admiral CSGA400AAL: 01 - Body Parts

Size: 10-24X5/16-NI

This infinite switch controls an electric cooktop's surface burner by varying power to the element, letting you dial in and maintain precise heat. Replacing a failed switch restores smooth temperature adjustment and reliable simmer-to-boil performance. What it does:

• Regulates AC power to the surface element based on the knob setting
• Restores full range of heat levels from low simmer to high
• Common failure symptoms: no heat, stuck on high, erratic temperature, or burner won't turn off
• Can correct intermittent heating or a knob that turns without changing heat

• One surface burner infinite switch

• Disconnect power at the breaker before servicing
• Remove the control knob and access the console/panel to reach the switch
• Transfer wires to the matching terminals on the new switch; secure the switch to the panel
• Reassemble, restore power, and test the burner through all settings

This snap-in bushing provides a low-profile bearing surface to support rotating shafts and reduce wear and noise in appliance assemblies. It restores smooth operation where the original bushing is worn or damaged. What it does:

• Provides a replaceable bearing/sleeve for rotating shafts and posts
• Reduces friction and wear on housing and moving parts
• Helps eliminate rubbing, grinding, or rattling noises during operation
• Maintains correct shaft alignment for smooth rotation

• One snap-in bushing

• Disconnect power before servicing and follow all safety instructions
• Access may require removing panels or covers; inspect surrounding parts for wear
• Press or snap the bushing squarely into the housing until fully seated; avoid deforming it
• Replace any damaged retainers or seals and test operation after reassembly

This factory fastener secures panels, trim, or brackets on your appliance. Replacing a missing or stripped screw restores a snug, rattle-free fit and keeps components aligned for proper operation and a clean, finished appearance.

• Fastens exterior panels, trim pieces, or internal brackets to the appliance chassis
• Replaces lost, damaged, or stripped hardware
• Helps prevent vibration, rattling, and gaps between parts
• Common signs you need this screw: missing hardware, loose or misaligned panel/trim, stripped head or threads

• Disconnect power before servicing; also shut off the gas supply
• Use the correct driver; start the screw by hand to avoid cross-threading
• Tighten snugly—do not overtighten to prevent stripping or cracking adjacent parts
• Repair or replace the mounting point before installing

For top surface burners. Configuration: 2 + 0.