Parts for Maytag MGDE300VF2: 01 - Top And Console Parts

Secures dryer wiring to the cabinet to prevent rubbing and interference. Replace if your wire retainer clip is broken, missing, or damaged.

Dryer won't start or has power issues? This 3-way terminal block receptacle connects the power cord to your dryer's electrical system. DIY-friendly.

Fix dryer electrical connection issues with this terminal. Used for wiring connections in heating and control circuits. Simple installation in minutes.

Dryer won't power on or trips breaker? This terminal block plug connects power to your dryer's electrical system. Common fix for power issues.

Fix dryer electrical connection issues with this terminal. Common when dryer won't start or power cuts out. Simple plug-in repair for most models.

Secures the handle end cap to the center of your refrigerator door. Replace if missing, stripped, or lost during handle repairs. 8-18 x 1/2 inch size.

Decorative medallion badge for dryer control panels. Replaces cracked, faded, or missing emblems. Restores the finished appearance of your dryer.

Dryer won't start or stops mid-cycle with buzzing? A cracked motor connector housing causes intermittent power to the motor. Quick DIY repair fix.

Replace your dryer seal to prevent air leaks and improve drying efficiency. Install when you notice gaps or worn edges. Verify fit with your model number.

5-circuit wire harness connector for dryers. Connects wiring harness to control board. Replace if cracked, damaged, or pins are bent or corroded.

2-position wire connector for dryers. Replaces damaged, melted, or corroded connectors in electrical wiring harnesses. Essential for restoring connections.

A replacement control knob that restores safe, accurate control of your appliance's settings. Simple push-on design matches original fit and lets you adjust temperature or function with a secure grip. What it does:

• Replaces a worn, cracked, or missing control knob so you can reliably change settings
• Engages the control shaft splines to provide positive, slip-free rotation
• Restores correct tactile feel for precise adjustments
• Helps prevent accidental changes caused by damaged knobs

• One control knob

• Disconnect power to the appliance before servicing to avoid shock or injury
• Pull the old knob straight off the control shaft; install the new knob by aligning splines and pushing firmly until seated
• Do not force the knob if it resists—check spline orientation and fit first
• If the control shaft is damaged or the knob does not seat properly, replace the control.

Secures the dispenser drawer bracket to the drawer assembly on front-load washers. Replace if stripped, missing, or corroded to restore a tight fit.

Control knob ring for dryer control panel. Replaces cracked, broken, or missing rings that secure the dial to the console. Essential cosmetic part.

Replace your dryer's internal wire harness if damaged, frayed, or showing exposed wires. Connects electrical components inside the dryer cabinet.

Mounting bracket for dryer. Secures components inside the cabinet. Replace if bent, broken, or missing to restore proper part alignment and support.