Parts for Electrolux PCWD3080AFB: 02 - Control Panel Parts

Fix unresponsive or inaccurate temperature control with this rotary potentiometer. Restores precise adjustment of oven settings. Moderate DIY repair.

Oven mode selector not working or stuck between settings? This potentiometer controls cooking mode selection. Common repair for faulty mode switches.

This terminal block provides the appliance's main wiring connection point, securely joining the incoming power leads to the unit's internal wiring for reliable electrical contact. It restores a solid, safe power feed when the original connector is damaged or worn. What it does

• Holds and secures incoming power conductors to the appliance wiring harness
• Provides firm electrical contact to prevent intermittent power or arcing
• Commonly replaced for loose, melted, or burned terminals or after a short or power-fault
• Helps restore normal power delivery when appliance will not power on due to a failed connection

• One terminal block assembly

• Always disconnect house power at the breaker or unplug the appliance before servicing
• Match wire positions to the appliance wiring diagram and tighten terminals firmly
• Inspect surrounding wiring and strain relief for heat or damage; replace any compromised components

This harness assembly is the factory-style wiring harness that routes power and signals between the appliance's controls and components, restoring reliable electrical connections and correct component communication. What it does:

• Provides the main bundled wiring to connect control board, switches, sensors, and motors
• Replaces damaged, chaffed, or corroded wiring that can cause intermittent operation
• Helps resolve symptoms like controls not responding, intermittent power to components, or components that run only sporadically
• Maintains correct connector fit and routing to prevent shorting or pinching

• Disconnect power (unplug or switch off breaker) before starting any repair
• Compare harness connectors and routing to the original to ensure correct replacement
• Handle connectors and terminals carefully; avoid pulling on wires
• Secure harness with existing clips/fasteners and verify no wires contact hot or moving parts; test appliance after reassembly

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.