Parts for Magic Chef 3512WRA: 02 - Control Panel Parts

Replace your range indicator light when dim, cracked, or not illuminating. Restores visible status for active functions and cycle progress. Verify fit.

Burner won't turn off or only heats on high? This infinite switch controls heat settings for your electric range's surface element. DIY repair.

Fix a burner stuck on high or an indicator light that won't turn off. This infinite switch controls heat settings on electric range burners. DIY-friendly repair.

Non-reset thermostat that monitors and controls appliance temperature to maintain consistent heating and help prevent overheating. Replaces a failed temperature control to restore normal heat cycles and safer operation in compatible electric appliances. What it does

• Opens and closes the heating circuit at preset temperatures to regulate appliance temperature.
• Restores proper temperature control when a failed thermostat causes no heat, intermittent heat, or overheating.
• Works with the appliance's existing thermostat mounting and wiring connections.
• Helps prevent repeated thermal shutdowns and irregular cycle performance caused by a faulty thermostat.

• Disconnect power to the appliance before servicing to avoid electric shock.
• Note wire locations or take a photo before removing terminals; reconnect wires to the same terminals.
• Test continuity with a multimeter to confirm replacement.
• Handle the thermostat and sensing elements carefully to avoid bending or damaging leads.

Color: Black. For biscuit order 98008169. For white order WP98008544.

Black control knob for electric range surface burners. Replaces cracked, stripped, loose, or missing infinite switch knobs. Restores heat selection.

This genuine replacement screw secures appliance components so panels, brackets, and assemblies stay tight and properly aligned. Replacing stripped, rusted, or missing hardware restores a solid fit and helps prevent rattles, shifting, or looseness over time.

• Fastens panels, brackets, and internal parts to maintain proper alignment
• Helps resolve issues caused by missing or damaged screws
• Restores secure mounting after service where original hardware is lost
• Use when threads are stripped or the screw head is damaged and won't tighten

• Disconnect power; turn off gas supply if applicable before servicing
• Match screw location and length to your model's parts diagram for correct placement
• Start threads by hand to avoid cross-threading; use the correct driver bit
• Snug firmly but do not overtighten to prevent damage to mounting points

Protects the bulb from moisture and contact while diffusing light. Replace when cracked or missing to restore safe, even oven lighting. Confirm fit.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Color: Black

This part has been discontinued by the manufacturer and is no longer available.

Self-tapping screw used in range assembly. Features 8-18 thread size and 0.375 inch length. Also used in some washer models as cross-appliance hardware.