Parts for Admiral GS2126CEDW: 03 - Controls Parts

Replacement mounting screw for refrigerator interior components and panels. Needed when original screws are stripped, lost, or damaged during repair.

This damper control regulates airflow between different compartments in your refrigerator to maintain proper temperatures. It automatically opens and closes to balance cooling between the fresh food and freezer sections. Replace this control if you have temperature imbalances, one section is too warm or cold, or you hear unusual clicking or motor noises.

Fixes loose panels, rattling doors, or wobbly components caused by stripped or missing screws. Secures brackets, covers, and mounting hardware. Easy DIY.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Replacement mounting screw for securing freezer panels, brackets, and components. Restores proper fastening where original screw is missing, stripped, or damaged.

Freezer icing up or not defrosting? A faulty defrost timer prevents the automatic defrost cycle. This rotary timer restores proper defrost timing.

A replacement door gasket that restores a tight seal around the oven door to help maintain proper cooking temperature and improve efficiency. Fits Whirlpool ovens and ranges that use part A3189394. What it does

• Seals the oven cavity to reduce heat loss and help maintain consistent cooking temperatures.
• Helps prevent heat from escaping around the door, improving energy use and cook results.
• Worn, torn, or flattened gaskets can cause uneven baking or longer cook times.
• Replacing a damaged gasket can reduce hot spots on the exterior and nearby cabinetry.

• Disconnect power and ensure the oven is completely cool before starting.
• Remove the old gasket by pulling it out of the door channel; clean the channel before installing the new gasket.
• Press the new gasket into the channel around the full perimeter, working from one corner and ensuring an even fit.

Refrigerator light won't turn off or on? The door switch detects when the door opens and closes. Easy 5-minute DIY repair with a pick tool or scraper.

Replacement mounting screw for refrigerator interior components and panels. Needed when original screws are stripped, lost, or damaged during repair.

This control wire harness connects the appliance control board to sensors, switches and powered components to restore electrical communication and proper function. It replaces a damaged or loose harness to help resolve intermittent or non-responsive controls. What it does:

• Carries power and low-voltage control signals between the main control board and components.
• Restores operation when frayed, burned, or cracked wiring causes intermittent circuits or loss of specific functions.
• Helps stop faults caused by broken connector tabs, corroded terminals, or detached plugs.
• Resolves error codes or unresponsive buttons that trace back to wiring faults.

• Disconnect power (unplug or switch off breaker) before starting; shock hazard exists.
• Compare the new harness to the original for connector type and routing before installing.
• Route and secure the harness exactly as the original using existing clips/retainers to avoid pinching or heat exposure.

(SOLENOID NOT AVAILABLE MUST ORDER ICE DOOR KIT 12001991)