Parts for Maytag MDE6700AZW: 03 - Drum Parts

Flat metal washer that sits under fasteners to distribute load and protect surfaces. Replace worn, missing, or corroded washers during repairs.

Replacement drum support roller for dryers. Mounts on the axle to support the drum and enable smooth rotation. Replace if worn, cracked, or noisy.

Transfers motor power to rotate the drum. Replace if dryer won't spin, makes squealing noises, or belt shows wear. Verify fit with your model number.

This sensor plate is located inside your dryer and detects the moisture level of your clothes as they tumble against it, signaling the dryer to stop when the load is dry. It allows the dryer to run on automatic dry cycles rather than fixed time, protecting your clothes from over-drying. Replace this part if your dryer stops too early and clothes come out damp, or runs too long and over-dries every load.

Color: gray. Measures about 13 inches wide by 11-1/2 inches high.

Tapping screw for refrigerator assembly and panel mounting. Replace when stripped, missing, or damaged during repairs or cabinet disassembly.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Wire harness not included. For harness use part number 35001164.