Parts for Electrolux FFRG1001PW0: 04 - Controls / Top Panel Parts

This is the main electronic control board for a dryer, managing cycle selections, temperature regulation, and timing functions. It processes input from the user interface and sensors to operate the heating element, motor, and other components. Replace this board if the dryer fails to start, does not respond to cycle selections, displays error codes, or behaves erratically during operation.

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

Replace your laundry center's worn, cracked, or missing control knob. This dial attaches to the control panel for cycle and temperature selection.

Door hinge pin for dryers. Secures the door hinge assembly to the dryer cabinet. Replace if the pin is bent, broken, or missing to restore door function.

Mounting bracket for dryer installation and structural support. Replace if bent, cracked, or broken to ensure proper appliance stability and secure fit.

This replacement screw fastens panels, brackets, and internal components so assemblies stay aligned and tight during operation. With an 8-18 thread and 0.711-inch length, it matches the original hardware for a precise, reliable hold.

• Secures panels, brackets, and internal components to the cabinet/frame
• Replaces missing, stripped, or corroded screws
• Helps reduce vibration, rattling, and gaps from loose hardware
• Restores proper alignment after service or transport

• Disconnect power and shut off water/gas before servicing.
• Support panels/components while removing and installing the screw.
• Start threads by hand to avoid cross-threading; tighten snugly—do not overtighten.