Parts for Gaggenau EB271-600: 04 - Door Parts

This inner door seal replaces the gasket that fits along the inside edge of the appliance door, helping restore a watertight and airtight closure for proper operation and cleaning. It's a direct-fit part for affected door assemblies. What it does

• Forms a sealed barrier between the door and tub to prevent leaks during cycles
• Restores proper door closure and helps maintain internal temperature and pressure
• Can reduce moisture build-up and visible drips around the door edge
• Helps prevent damage to cabinetry and flooring from escaping water

• One inner door seal (single gasket piece)

• Inspect the door and surrounding trim for damage; replace any broken retainers before installing the seal
• Clean the gasket channel and mating surfaces, then press the new seal evenly into the groove until fully seated
• Use caution to avoid sharp edges; wear gloves and follow manufacturer safety guidance

This middle door frame is the OEM replacement panel that restores the door's structure and alignment, improving fit and appearance. Use it when the center section of the door is dented, cracked, or no longer secures the door components properly. What it does:

• Replaces the middle section of the appliance door to restore structural support and proper alignment
• Helps eliminate gaps, rattles, or misalignment caused by a damaged or bent door frame
• Provides the backing surface for door trims, glass, and internal components to mount correctly
• Maintains the door's original fit and finish when the original middle frame is compromised

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Remove the door according to the appliance service instructions; support the door to prevent dropping
• Keep and reuse any original screws, clips, or seals unless replacements are specified as included

This male door latch striker secures the appliance door when closed, restoring a proper seal and reliable door engagement. Replace a worn or broken striker to stop door-not-closing issues and restore normal operation. What it does:

• Holds the door closed by engaging the door lock assembly for a secure seal
• Replaces a bent, broken, or worn striker that can cause the door to pop open
• Helps prevent leaks and interruptions caused by an improperly seated door
• Works with the existing latch/lock assembly to allow the door to lock and unlock normally

• One male door latch striker

• Disconnect power before servicing to avoid electrical shock
• Replace only the striker shown and verify alignment with the latch assembly
• Tighten mounting fasteners securely but avoid over-torquing plastic components
• If the door still won't latch after installation, inspect the mating latch/lock for wear

This inner door glass panel replaces a cracked, scratched or broken dishwasher door glass to restore the door's sealed surface and appearance. It provides a durable, smooth barrier that helps contain water and supports the door assembly. What it does:

• Replaces damaged or shattered inner door glass to restore door integrity and appearance
• Helps contain steam and water inside the tub by providing a smooth, sealed surface
• Reduces visible wear, scratches, and cosmetic defects on the dishwasher door
• Supports proper operation of the door assembly when installed correctly

• Disconnect power and water to the appliance before starting any repair.
• Handle glass with heavy-duty gloves and eye protection; glass can break and cause injury.
• Installation typically requires removing the outer door panel and fasteners; follow the OEM service instructions for your model.

This door handle assembly replaces a worn or broken oven door handle to restore safe, stable door operation and improve appearance. It's a direct-fit assembly designed to mount where the original handle connects to the oven door. What it does:

• Provides a secure grip for opening and closing the oven door
• Restores proper door alignment and reduces wobble or looseness
• Helps prevent accidental drops or slippage when handling the door
• Addresses symptoms like loose, cracked, or missing door handle components

• Installation requires accessing the oven door—disconnect power and allow the appliance to cool before starting
• Use appropriate hand tools; handle glass and metal parts carefully to avoid damage or injury
• Follow manufacturer instructions for reassembly; test door operation before returning the oven to regular use