Parts for Electrolux GCWD3067AFC: 04 - Lower Oven Parts

Replacement air fry tray for wall ovens. Holds food above the oven surface for even airflow and crisping. Replace if cracked, warped, or missing.

Flat wire oven rack that sits on interior supports to hold cookware at the correct height. Replace your bent, rusted, or missing rack to restore stability.

This is a door-activated switch that detects whether the oven door is open or closed. It controls functions such as the oven light or signals the control board about door position. Replace this switch if the oven light stays on or off regardless of door position, or if the oven does not operate correctly due to a faulty door signal.

Replace a cracked, broken, or missing oven door spacer that maintains proper alignment and gap between door components. Installs in door assembly.

If your oven temperature is inaccurate or food cooks unevenly, the temperature probe may have failed. This sensor monitors cavity heat levels.

This refrigerator door hinge secures and guides the door, restoring proper alignment and smooth opening. Replace a worn or damaged hinge to stop door sag, reduce rubbing or grinding, and help the door seal correctly. What it does:

• Supports the refrigerator door and keeps it aligned on the cabinet
• Guides door movement for smooth opening and closing
• Prevents door sag that can cause gaps and cooling loss
• Stops binding, scraping, or noisy operation caused by a damaged hinge

• Unplug the appliance or shut off power before starting any repair
• Support the door while removing and installing the hinge to prevent injury or damage
• Use the original fasteners or OEM-equivalent screws and tighten to proper snugness
• Check door alignment and gasket seal after installation; adjust hinge position as needed

This replacement evaporator fan blade helps circulate cold air inside the freezer or refrigerator compartment to maintain even temperatures and proper cooling performance. A direct-fit replacement when the existing blade is cracked, warped, or missing. What it does:

• Moves air across the evaporator to promote even cooling and frost prevention
• Restores proper airflow when a damaged blade causes noise or reduced cooling
• Helps reduce hot or warm spots inside the compartment
• Quiet, balanced operation when installed correctly

• One replacement evaporator fan blade

• Disconnect power to the appliance before starting any repair
• Typically accessed by removing interior panels in the freezer/refrigerator compartment
• Inspect the fan motor shaft and mounting for damage before installing the new blade

This is a mounting nut used to secure the fan blade to the motor shaft inside a range or oven. It keeps the convection or cooling fan firmly attached so it spins properly during operation. Replace this nut if the fan wobbles, rattles, or has come loose from the motor shaft.