Parts for Gaggenau EB378-610: 05 - Internal Panel `B` Parts

This fan motor powers the appliance's blower to circulate air for proper cooling and ventilation, restoring airflow and helping maintain consistent temperatures. It replaces a failed motor to stop noise or loss of circulation. What it does:

• Spins the blower to move air through the appliance for cooling, exhaust, or circulation
• Restores normal airflow when the appliance has weak or no air movement
• Stops excessive motor noise or vibration caused by a worn or failing motor
• Helps prevent overheating by re-establishing proper ventilation

• Disconnect power to the appliance before starting any repair
• Handle the motor carefully; avoid exposing electrical connections to moisture
• Basic hand tools are typically required; refer to the service manual for disassembly steps
• Secure all connectors before testing

This temperature limiter is a safety thermostat that stops heat when temperatures exceed safe limits, protecting the appliance from overheating and potential damage. It's a direct-fit replacement designed for the original thermal cutoff function. What it does:

• Monitors heater temperature and opens circuit if the unit overheats
• Prevents continuous heating that can cause component damage or fire risk
• Common failure symptoms: appliance won't heat, intermittent heating, or tripped thermal safety
• Works as part of the heating/temperature-control safety chain

• Disconnect power (and gas if applicable) before access and replacement
• Located near the heating element or blower housing; follow your model's service manual for access
• Inspect wiring and adjacent components for heat damage; replace damaged parts as needed

This 750 ohm fixed resistor restores the correct resistance on the appliance control circuit so the control board can operate reliably. Use it to replace a burned or open resistor that interrupts normal electrical function. What it does:

• Provides a precise 750 O resistance value used in control and sensing circuits
• Limits or drops voltage to protect downstream components
• Restores stable control-board signals when the original resistor is open or damaged
• Commonly linked to symptoms like intermittent operation, control errors, or failure to start

• Disconnect power to the appliance before attempting service
• Handle the resistor and circuit board carefully to avoid damage; observe ESD precautions
• Confirm orientation and solder joint quality when installing; use proper tools and techniques

This terminal connector provides a secure electrical connection for appliance wiring, replacing a worn or damaged spade-style terminal to restore reliable power flow. It fits into the appliance's existing terminal block for a lasting repair. What it does:

• Replaces a damaged or corroded spade terminal to re-establish a solid electrical connection
• Helps eliminate intermittent power, arcing, or overheating at the wiring junction
• Works where a right-angle terminal is required to connect a wire to the appliance terminal block
• Compatible with standard insulated or non-insulated spade-style wire terminations

• Disconnect power at the circuit breaker or unplug the appliance before inspecting or replacing terminals
• Verify terminal orientation and fully seat the connector on the mating spade to ensure a tight fit
• Use proper crimping or soldering techniques if attaching bare wire; avoid loose or exposed conductors

This oven thermostat regulates and senses cooking temperature to help the oven maintain set heat levels for consistent cooking. Replaces a failed temperature control to restore accurate oven temperature and stable bake/broil cycles. What it does:

• Senses oven temperature and signals the heating elements or gas valve to cycle on/off
• Restores accurate temperature control when the oven runs too hot, too cold, or won't hold temperature
• Helps prevent extended run times and uneven cooking caused by a faulty thermostat
• Compatible with control assemblies that use this style of electro-mechanical thermostat

• Disconnect power to the appliance before attempting any repair
• Follow manufacturer service instructions and wiring diagrams for correct connection and calibration
• Use caution handling the unit and mounting hardware to avoid damage; replace any grommets or mounting clips if worn