Parts for Electrolux EFDC317TIW2: 05 - Motor Parts

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

Replace your dryer's cabinet mounting spacer if cracked, broken, or missing. Maintains proper clearance between panels and components inside the cabinet.

This gasket forms an airtight seal around the dryer's blower housing to ensure proper airflow through the exhaust system. It prevents heated air from leaking into the dryer cabinet instead of being directed out the vent. Replace this gasket if the dryer takes too long to dry clothes, the cabinet feels excessively hot, or you notice air leaking around the blower area.

This is a gasket that seals the exhaust duct connection on a dryer, preventing hot air and moisture from leaking into the surrounding area. It fits between the dryer's exhaust outlet and the vent duct to ensure a tight, airtight seal. Replace this gasket if you notice warm, moist air escaping around the back of the dryer, reduced drying efficiency, or visible deterioration and cracking of the old seal.

Replacement screw for securing dryer trim, panels, and interior components. Needed when original fastener is lost, stripped, or damaged during repair.

Dryer won't start or shuts off mid-cycle? This thermal fuse cuts power when overheating occurs. Common fix for E63, E66 errors. DIY repair under 1 hour.

Dryer making loud rumbling or tapping noise? A worn or damaged blower wheel assembly is often the cause. Moderately difficult repair for most DIYers.

Dryer not drying evenly or taking too long? This blower assembly circulates air for proper airflow and consistent drying. Restores performance.

Small spacer that fits on the idler assembly shaft to properly align the belt tensioner. Replace if worn, cracked, or missing to maintain proper spacing.

Fix dryer heating issues with this thermistor temperature sensor. Solves intermittent heat, cycle errors, and poor drying. Easy DIY repair.

Threaded fastener that secures and spaces dryer components. Replace if the original spacer screw is missing, stripped, or damaged during repairs.

Idler spring attaches to the idler arm to maintain proper belt tension. Replace if spring is broken, stretched, or missing to restore correct tension.

Idler arm assembly mounts near the dryer drum to guide and tension the belt. Replace if the pulley is worn, cracked, or causing belt misalignment issues.

Transfers motor power to rotate the drum. Replace if dryer hums but won't spin or makes squealing sounds. Verify fit with your model number.

Secures the dryer motor in proper position for stable operation. Replace if motor shifts, buzzes, or clamp strips out. Confirm fit with your model number.

Dryer won't start or drum won't turn? A failed motor is often the cause. This motor drives the drum and blower. Moderate DIY repair, 1-2 hours.

This metal bracket mounts and secures the drive motor inside the dryer cabinet. It provides structural support to keep the motor properly aligned with the drum belt and pulley system. Replace this bracket if it is bent, cracked, or corroded, which can cause excessive motor vibration, unusual noises, or misalignment during operation.

Phillips pan head screw for securing panels and components in appliances. Replace missing, stripped, or corroded screws during repairs or maintenance.