Parts for Maytag LAT2600AAE: 06 - Top Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Washer shaking or stopping mid-spin? This unbalance plunger detects off-center loads to maintain proper spin speed. Direct replacement part.

Small plastic ball component that snaps into washer lid hinge mechanism. Replace when missing, cracked, or broken to restore smooth lid opening and closing.

Screw: 8-16 x 3/8 inch.

Fix washer overfilling or not filling properly with a new water level pressure switch. Controls fill shutoff and cycle transitions. DIY repair.

Tension spring restores proper movement in washer mechanical assemblies. Replace if parts sag, rattle, or don't return to position. Confirm fit by model.

Replacement mounting screw for securing panels, brackets, and components in dryers, refrigerators, and washers. Needed when screws are lost or stripped.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Washer won't start or spin? A faulty lid switch prevents operation when the lid position isn't detected. Simple clip-in replacement, typically done in 10 minutes.

This lid bumper cushions the contact point between a washer lid and the top panel to reduce slamming noise and protect the finish. Replacing a worn or missing bumper restores smooth, quiet lid operation and helps prevent paint damage.

• Provides a soft stop between the lid and top to minimize noise and vibration
• Helps prevent chips, scratches, and rust where the lid meets the cabinet
• Maintains proper lid spacing for a solid, rattle-free close
• Common signs it's needed: missing/flattened bumper, louder closing, rattling, or visible wear at contact points

• Disconnect power before servicing
• Open the lid, remove the old bumper, and clean the mounting area
• Seat the new bumper fully in the mounting location as designed
• Open/close the lid to ensure quiet, secure contact

Bleach not dispensing or cup cracked? This washer bleach dispenser cup snaps into the top panel. Easy DIY fix—just push down to lock in place.

Washer shaking or stopping mid-spin? This unbalance plunger detects off-center loads to maintain proper spin speed. Direct replacement part.

Screw: 8-16 x 3/8 inch.

Screw: 8-16 x 3/8 inch.

Screw: 8-16 x 3/8 inch.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.