Parts for Crosley CDE2000FW0: 07 - Controls / Top Panel Parts

Replace your dryer's control panel knob if it's cracked, broken, or missing. This knob installs on the control panel for cycle and setting selection.

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

Dryer won't start when you turn the knob? A faulty start switch prevents the motor from engaging. Simple 5-10 minute DIY fix with basic tools required.

Control board mounting bracket for dryers. Secures the electronic control board to the dryer frame. Replace if bracket is cracked, bent, or missing.

Secures panels, brackets, and trim on appliances. Replace when missing, stripped, or damaged to restore a tight, rattle-free fit and proper alignment.

Replacement timer knob for dryer control panel. Attaches to timer shaft to select drying cycles. Needed when original knob is cracked or broken.

This console is the exterior control-panel trim that covers and supports the appliance's controls and display, restoring a clean finished look and access to the control area. What it does

• Replaces a cracked, warped or severely scratched control-panel trim piece
• Restores secure mounting and alignment for control knobs, buttons or display overlays
• Prevents debris and moisture from entering the control area through damaged trim
• Improves appearance and user access when the original console is cosmetically or structurally compromised

• High-level replacement: typically removes with basic hand tools; handle panels carefully to avoid scratching
• Disconnect power (and gas or water if appliance type requires) before starting work
• Keep screws and small fasteners organized; alignment tabs must seat properly to avoid gaps

White top panel for stackable dryers. Replaces cracked, damaged, or discolored panels. Installs on top of dryer unit to restore appearance and protect.

Dryer won't start or smells like burning? A melted or loose terminal block where the power cord connects is often the cause. Easy 20-minute repair.