Parts for Maytag MLG19PRDWW: 09 - Door & Front Panel (Washer) Parts

Double

Single

This grommet seals and cushions the dryer/refrigerator vent tube where it passes through the cabinet, helping prevent air leaks and reduce vibration noise. It restores a tight vent connection for proper airflow and quieter operation. What it does

• Provides a secure, flexible seal around the vent tube to reduce air leaks.
• Cushions the vent tube to minimize vibration and rattling during operation.
• Helps maintain proper airflow by keeping the vent connection aligned.
• Commonly replaced when cracked, torn, or excessively worn.

• One vent tube grommet.

• Turn off and unplug the appliance (or disconnect power) before starting any repair.
• Access may require removing the back panel or interior trim—follow your model's service instructions.
• Inspect surrounding vent tubing and fasteners; replace any damaged components for a complete repair.

This vent tube assembly directs exhaust airflow from the dryer to the cabinet exit, restoring proper venting and reducing moisture buildup. It's a direct-fit replacement that helps return your appliance to normal drying performance. What it does:

• Channels hot, moist air from the dryer drum to the exhaust outlet to prevent interior condensation.
• Replaces damaged, crushed, or disconnected tubing that can cause poor drying or longer cycle times.
• Helps reduce lint accumulation at the blower assembly by providing a continuous exhaust path.
• Can resolve symptoms like reduced drying efficiency, excess humidity around the appliance, and unusual airflow noises.

• One vent tube assembly

• Disconnect power (and gas supply if applicable) before starting any repair.
• Access the dryer rear or cabinet per your model's service instructions to remove the old tube and install the new one.
• Ensure the tube is routed without sharp bends or kinks and secure clamps/fasteners tightly to prevent leaks.

This hinge screw fastens a hinge to the appliance cabinet or door, helping keep the door aligned and operating smoothly. Replace a missing or stripped screw to restore solid hinge support and reliable closure.

• Secures the hinge to the cabinet/frame or door
• Maintains proper alignment at the hinge point
• Helps ensure smooth opening/closing and effective sealing where applicable
• Common symptoms: loose or wobbly hinge, door sagging/misaligned, poor closure/seal, rattling, or a missing/stripped fastener

• Disconnect power to the appliance; shut off gas if applicable
• Support the door to relieve hinge load before removing or installing screws
• Use the correct driver for your model to avoid stripping fasteners
• Start threads by hand and tighten snugly; do not overtighten

This door hinge secures and guides a refrigerator door, restoring proper alignment and smooth opening/closing. Replaces a worn or damaged hinge to reduce sagging, rubbing, or uneven gaps and help maintain a tight door seal. What it does:

• Provides the pivot point that supports and aligns the refrigerator door
• Restores correct door height and gap to prevent rubbing or catching
• Helps the door close fully to maintain proper temperature and efficiency
• Reduces sagging or drooping that can cause seal and cooling issues

• One door hinge

• Disconnect power to the appliance before beginning any repair to avoid electrical hazards
• Support the door during removal/installation to prevent injury or damage to the cabinet
• Use the same fasteners provided or retained from the original hinge; torque per manufacturer guidelines
• Adjust hinge position per service instructions

Note: This part is one screw, order quantity needed.

Specs: No.8-18AB WAFER HD

Color: White