Ace Parts

This is a ratchet pawl assembly used in the recoil starter mechanism of a string trimmer. It engages the starter pulley to turn the engine over when the pull cord is yanked. Replace this part if the pull cord pulls freely without engaging the engine or if the trimmer fails to start due to a slipping or broken starter pawl.

Blade guard assembly for line trimmers. Protects operator from debris and rotating components. Replace if cracked, broken, or missing for safe operation.

Rubber spiral auger kit for snow blowers. Replace when rubber paddles are worn, cracked, or no longer effectively move snow. Confirm fit with your model.

This is the trimmer head assembly for a string trimmer, housing the cutting line and feed mechanism. It attaches to the end of the drive shaft and spins at high speed to cut grass and weeds. Replace it if the line no longer advances properly, the head is cracked, or the internal spool mechanism is worn out.

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

Throttle cable for gas line trimmers. Connects carburetor to throttle trigger. Replace if damaged, kinked, frayed, or broken during use.

This is a quality rear engine cover that is used on several types of string trimmers. The component is tightened onto the back of the trimer to offer protection and shielding to the engine. It is made of a durable material and comes with both the cover and four screws to attach it to a string trimmer. Over time, the rear engine cover can become damaged, broken, or lost and should be replaced to ensure the engine is protected.Check the rear engine cover for cracks and other damage before installing a new replacement part. First, remove the screws from the rear engine cover so it can be taken off of the string trimmer. An O-ring may be needed to create the proper clearance when installing the new rear engine cover. Make sure to properly tighten the screws on the cover before use.This rear engine cover is an authentic OEM replacement part that is sourced directly from the manufacturer. It is sold as an individual component. The engine cover is designed to be compatible with string trimmers manufactured by Bolens, MTD, Yard Machines, Murray, and Craftsman.

This flywheel assembly mounts on the engine crankshaft of a gas-powered line trimmer and provides the rotational mass needed to keep the engine running smoothly between power strokes. It also drives the ignition system by passing magnets over the ignition coil to generate spark. Replace this flywheel if the engine has no spark, runs erratically, or if the flywheel is cracked, has damaged magnets, or a sheared keyway.

Throttle control cable for gas line trimmers. Connects trigger to carburetor for speed control. Replace if cable is frayed, stiff, or broken.

Carburetor assembly for edgers and gas trimmers. Mixes fuel and air for combustion. Replace if cracked, damaged, or leaking to restore proper operation.

Ignition coil module for gas line trimmers. Mounts to engine block to generate high-voltage pulses for spark plug. Replace if cracked or damaged.

Ignition coil module assembly for gas string trimmers. Mounts to engine block and connects to spark plug. Replace if cracked, damaged, or contacts are worn.

Ignition module for gas leaf blowers and line trimmers. Mounts to the engine to control spark timing. Replace if cracked, damaged, or missing.

Fix a gas line trimmer that won't start with this starter assembly. Replaces worn recoil mechanisms causing hard pulls or no-start conditions.