Admiral Dryer Light, Bulb, Lamp

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Originally the dryer was squeaking a lot, so I purchased a new belt tensioner, but the original tensioner was an old-style no wheel tensioner, so that wasn't the source of the squeaking. I saw a lot of lint had built up inside the unit where there shouldn't have been that much. So I viewed a few videos on the Appliance Pros site and saw that the rear wheel guides were the cause of the squeaking and the rear felt drum and blower housing seal needed to be replaced. The rear blower housing was... Read more

Dropped light panel by removing two screws with socket set. Unplugged two terminals and unclipped the light socket from the base. Then just clipped the new socket onto the base, plugged the connectors onto the terminals and remounted the base. Total job was less than 15 minutes. Read more

I went on line and purchased all of the possible parts that could be worn out. I spent less than the service guy wanted to show up...The online videos were spot on. Two hours and it works like new! One of the best values on the Internet! Read more

Purchased the triple burner and dual burner element. I added my model of stove and I was able to pull up diagrams of the stove parts. The parts were easy to find using the diagrams and the burner elements were marked 17 & 15 so I placed my order. Parts were here in a couple of days. The tricky part was figuring out how to get into the stove top. I was a few youtube videos to see different replacement. My husband and I got the stove top off and flipped it over on the counter. We looked at... Read more

Replaced coils on gas valve; while at it replaced door screws which were starting to wear from assorted repairs over the years. Read more

• Light not working

I bought a new bulb but it did not work. Then the super looked at it and realized the socket was not good. Read more

I replaced the controller. I had a heck of a time figuring out how to get to it. The video on the website showed access to the control via the rear panel. On the Kitchen Aid we have, the back panel is part of the range's main frame and does not come off. Turns out, 2 screws behind the fluorescent lamp had to be removed and the entire control panel housing lifts up and can be tilted forward. (I needed to clean behind the range anyway, so it was no big deal)!! The replacement part instructions... Read more

Had to find the correct bulb for a Kenmore freezer. AppliancePartsPros made it east with the feature that lets you verify the model number of the freezer to the correct size light bulb. Great feature. Read more