Parts for Whirlpool A0W22W20: Air Flow And Control Parts

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This seal strip replaces a worn or damaged door gasket edge to restore a proper seal and help the appliance maintain temperature and operate quietly. It's a direct-fit service part used where a continuous seal is required. What it does:

• Provides a flexible barrier along the door/frame to reduce air leaks and heat/cold loss
• Helps prevent moisture buildup and improves energy efficiency when sealing is restored
• Reduces rattling and vibration caused by a compressed or torn seal edge
• Commonly replaced when the strip is torn, missing, or no longer adheres properly

• One seal strip

• Disconnect power to the appliance before servicing to avoid electrical or burn hazards
• Clean and dry the mounting surface; remove old adhesive or residue for best adhesion
• Align the strip carefully and press firmly; allow any adhesive to cure per manufacturer instructions

This replacement control knob restores a damaged or missing stove/oven/range control interface so you can set temperature and function precisely. It provides a like-for-like external control for models that use this original-style knob. What it does

• Replaces a cracked, stripped, or missing control knob so dials turn smoothly
• Provides a clear tactile stop and position indexing for accurate settings
• Helps resolve symptoms like slipping on the shaft, loose fit, or broken knob grip
• Restores safe, intuitive control of the oven/range functions

• One replacement control knob

• Typically installs by pulling the old knob straight off the shaft and pushing the new knob fully onto the splined shaft
• Confirm correct orientation and alignment before use; test function at low setting first
• Disconnect power or follow manufacturer safety guidance if working near live controls
• If the shaft or underlying switch is damaged, replace the defective component rather than relying on the knob alone