Christopher for Model Number ATF6700FS1 Our washer has stopped spinning. The tub had drained and I checked the trap at the pump for debris which we have found full of stuff two other times but not this time. I checked codes and found E41 door lock switch malfunction. I checked the J2 connector per the instructions and found 120 volts at the black wire. It appears to be the main control board per the manual but after looking on the net it makes me wonder. One thing that I thought was odd was the pump would run when we selected spin only although no water was present. I am prepared to buy the board if need be, your thoughts?
Answer Hello Christopher, This sounds like a door lock assembly 131763256 issue as long as all of the connections have been unplugged and re-attached since many problems with these unit are due to poor electrical connections. If the door lock assembly is the issue, you will also need to order part numbers 134606800 harness and 131763310 door strike. As far as the pump running as you mentioned, there is nothing unusual about this. Read More... Answered by AppliancePartsPros.com | Thursday, December 26, 2013