W.S. for Model Number LTF2940ES3 Hello. I have been having problems with my washer for some time now. It first started giving us problems when it would turn on by itself and say PAU, in the LED screen. Once that happened, if you tried to push cancel or any button if would give the ERR error code. We ran the diagnostic and got he E41 error code but the washer would still work. A few times the washer didnt finish its cycle, more times than not it would get stuck on 1 at the end of the cycle. Then if you tried to cancel, it would give the ERR code again. We would then shut it off, turn the dial to the start position (touch-up) and it would work normally most the time for a cycle or two but then go back to the same problem. I messed with the door switch and tried a continutiy test on the plug J2 and could only get a reading of 1 therefore I think its the control board, is that the correct thinking?. In the washer tech data sheet it says to replace the control board, is that the electronic control up top or the motor control board underneath the machine? Please Help!
Answer Hi. E41 code is the door latch part # 131763256. It will bring up the PAU(se) code and ERROR codes when it is not latched fully. It is a 2 stage latch system that the control board part # 137006000 monitors for safety. The unit will not spin if the door latch is not closed and the drain pump part # 137221600 will not drain (CLOGGED). Thank you. Read More... Answered by AppliancePartsPros.com | Tuesday, November 6, 2012