Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Main Control Board by Frigidaire

4.89 (64)
By: Frigidaire
Part Number: OEM13076436
Manufacturer Part Number: 137006000

Washer won't start, shows error codes, or cycles randomly? The main control board manages all wash functions. Moderate DIY repair with careful handling.

More
$237.62

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Frigidaire Washer Main Control Board (Part Number: OEM13076436)

View all Questions

Rich for Model Number GLTF2940ES0

My front load washer is seven years old. The problem I have with the machine is the machine cuts off about halfway through the wash cycle. The drum is half full of water, so obviously nothing is draining. The error code was E23. I replaced the Control Board, printed circuit, with housing (part 134523103). the washer did the same thing again. I put the old control board back in and replaced the Control Board, motor (part 134409902). the washer did the same thing again. it is still showing E23 as the error code. Now the digital display does not coincide with the dial indicator (it is set on Drain and Spin yet shows 55 minutes on the digital display, which is a Normal Wash cycle time) I'm getting tired of this. What else could be the problem?

Answer

Hi. E23 code is a drain pump relay on the control board code. But realize all codes are specifically set for a specific issue including all the components such as the board, Wire connections, and wires to the device. The pump part # 137221600 has to drain all the way while the door latch part # 131763256 is closed for safety. So remove the front lower panel and empty the drain catch (mounted behind the screw off 3" cover). Use towels and a shop vac to pick up all the water, there will be a lot (trust me). If the pump impeller spins loose on the pump shaft,replace it as well if it is clogged with water in the armature. Past the seal and ruined the pump. Once all of this is clear, run the unit in spin to reset the controls and the pressure switch once again. Thank You.

Read More...

Answered by AppliancePartsPros.com   |   Tuesday, November 6, 2012

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro

Share your thoughts with other customers

Answer or comment
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google