William S for Model Number LTF2940ES3 Hello, I have been having trouble with my washing machince for some time now. It first started when the machine would stop in the middle of the cycle all by itself, and then the LED screen would read PAU, and if you tried to hit any buttons it then gave an ERR for Error. We did the diagnostic tests and were able to get the error code E41 which said the control board thinks the door switch is open. The washer still worked by we would periodically need to turn the machince off, turn the dial to the start position (touch-up) let it set for a little while and turn it back on, it would then work for a little while and we would do the same process. Now, all I can get is the PAU on the LED display, even if I unplug the machine, let it set and re plug it in on the start postion, I only get the PAU and if I try to hit the cancel button it just gives the ERR code. Is this the control board? In the Tech Data sheet provided it states its either the door switch or the control board. Which control board is it, the one with the buttons on top of the machine, or underneath the machine, the motor control board? Thanks! Bill S
Answer Bill, The E41 error, does indicate an issue with the door latch assembly 131763256, " E41 Control board thinks the door switch is open.Test 7: Remove the door lock assembly and measure the resistance of the PTC. Shorted or open. Defective door lock assembly.Around 1500Ohms. Defective control board." But first check the door alignment Front panel and hinges for proper alignment and closure. If alls OK, replace the latch assembly. The motor control board or the main control board 137006000 are the least likely issues at this time Read More... Answered by AppliancePartsPros.com | Tuesday, November 6, 2012