Donnie for Model Number whirl pool duet wfw8300sw04 When you press the power button, it won't light up but a code 1 will come up. Is my ccu board burnt out are is something else bad?
Answer Donnie, The F1 error code is an indication of Pump driver/Main relay/EEPROM error. Check for loose power outlet. A loose power plug in the wall can create a line noise and issues. Check if the washer is on a dedicated circuit. Other devices on same circuit can create line noise and cause this issue. Unplug the washer or disconnect power. Make sure that wire harness connections from the CCU are not broken or with wires detached, and that connector internal pins are visible. Make sure that all green wires (ground harness system) are not broken or detached. Make sure the two ground switches are pressed correctly by the toe and rear panels. Make sure all connectors are fully seated. Plug in washer or reconnect power. Check for power going to CCU by listening for a click in the CCU when unit is plugged in washer or when reconnecting power. If the unit still has the error then the control board would need to be replaced. Read More... Answered by AppliancePartsPros.com | Wednesday, July 10, 2013