Dirk H. for Model Number 66513484k902 Our dishwasher keypad panel has no lights that illuminate. The only button that appears to work is the Cancel button. The unit then goes into drain mode and pumps the water out. How do we go into self test mode? What do you recommend? Thanks
Answer Hello Dirk, To invoke the Diagnostics Cycle, perform the following key presses or actions in less than 6 seconds while in standby: Heated Dry ? Normal ? Heated Dry ? Normal To rapid advance one interval at a time, press the Start/Resume key. Invoking Service Diagnostics clears all status and last ran information from memory and restores defaults; It also forces the next cycle to be a sensor calibration cycle. Calibration cycles begin with a “sensor check” to determine whether the dishwasher has an OWI soil sensor. If the control detects an OWI, it forces two rinses to occur prior to Final Rinse (to assure clear water), then calibrates the OWI during the final rinse. The tech sheet behind the kick panel explains this and also explains the fault codes. Read More... Answered by AppliancePartsPros.com | Thursday, August 28, 2014