Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Water Level Pressure Switch by Whirlpool

4.89 (64)
By: Whirlpool
Part Number: OEM20943129
Manufacturer Part Number: W11417619

This water level pressure switch senses air pressure from the tub and signals the control to stop filling at the correct level. Replacing a weak or failed switch restores proper filling, helps prevent over/underfilling, and allows cycles to advance.

  • Monitors tub water level via the pressure hose and sends the level signal to the control
  • Stops water flow at the target level so wash, rinse, and spin can begin
  • Common symptoms of a failing switch: continuous filling, overfilling or underfilling, cycle won't advance past fill/sensing, or stops with water still in the tub
  • A cracked, kinked, or blocked pressure hose can mimic switch failure—inspect during diagnosis
What's included: 1 water level pressure switch Install notes:
  • Disconnect power and turn off water supply before servicing
  • Access the switch from the console/top or rear panel per your model; note wire orientation
  • Transfer and firmly seat the pressure hose; inspect it for kinks, cracks, or blockages and replace if damaged
  • After installation, run a fill test; some models may require a diagnostic calibration—see the tech sheet or user manual

More

Questions & Answers

For Whirlpool Water Level Pressure Switch (Part Number: OEM20943129)

View all Questions

Cindy for Model Number MHWZ600TB01 EPIC Z MAYTAG FRONTLOAD WASHER

I turned off the washer and pressed start the add garment light goes on and the door locks and it spins over once - then the door unlocks and it goes off. I repeated this process several times and sometimes it just clicks twice and the lights on front panel stay on along with the add garment light then door unlocks and it turns off. Water had leaked out of the door area and it did not finish the load just stopped working?? Any suggestions on what is going on or what parts I need to fix this problem?

Answer

Cindy, Do you not have a failure/error code in the display ? one of two things has occurred; One of the switches of the door lock assembly has failed and is not sending the circuit to the CCU, or The CCU is not seeing the circuit. The ewasher control does not think the door has not been opened or closed, between cycles. WPW10525358 and WPW10253483 would be the place to start. Good Luck and Thanks

Read More...

Answered by AppliancePartsPros.com   |   Saturday, September 10, 2011

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro

Share your thoughts with other customers

Answer or comment
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google