Parts for Frigidaire TEF362BBBB: 02 - Backguard Parts

This instrument mounting plate secures the appliance control or instrument cluster inside the cabinet, keeping electronic components aligned and stable for reliable operation. It helps restore proper fit and prevents movement that can cause noise or poor connections. What it does:

• Provides a firm mounting surface for the control board or instrument cluster
• Keeps connectors and wires properly positioned to maintain electrical connections
• Reduces vibration and rattling from loose or damaged mounting points
• Restores alignment so buttons, displays, and knobs operate correctly

• One instrument mounting plate

• Disconnect power before starting any repair to avoid electrical shock
• Retain or reuse original screws unless replacements are specified; verify screw sizes before installation
• Handle edges carefully; mounting plates may have sharp edges
• Check alignment and connector seating before reassembling the cabinet panels

Black right-side end cap for range control panels. Replaces cracked, broken, or missing endcaps that leave control panel edges exposed or unfinished.

Black left-side endcap for ranges. Replaces cracked, broken, or missing endcaps on the left edge of your range. Restores appearance and finish.

Push button shaft for range clock and timer controls. Replaces broken, worn, or missing shafts that prevent proper button operation on your control panel.

This trim/vent is the decorative grille that installs on the refrigerator front to cover and direct airflow around the lower service area, restoring appearance and proper ventilation. Durable plastic matches factory fit and finish. What it does:

• Covers the lower front/service opening and hides internal components for a finished look
• Helps direct airflow around the condenser/vent area for normal operation
• Replaces cracked, broken, or warped trim that can catch dirt or snag floor mats
• Restores secure mounting where clips or tabs have failed

• One trim/vent grille

• Remove power to the appliance before starting any work
• Usually installs by lining up tabs and snapping into place; use care to avoid breaking plastic clips
• If mounting clips are damaged, replace them before reinstalling the trim
• No special tools typically required;

Range burner not heating or temperature won't adjust? This surface element control switch regulates heat output. Moderate DIY repair in 30-45 minutes.

Burner stuck on high or won't heat? This surface element switch controls temperature for electric range burners. DIY repair in under 30 minutes.

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

Support plate for range spice rack. Mounts inside the range to secure the spice rack assembly. Replace if cracked, broken, or missing for proper support.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.

Replacement truss head screw for countertop microwaves. Secures internal components and panels. Order when original screw is stripped, missing, or lost.